✦ LIBER ✦

The PVT behavior of isopropyl alcohol at elevated temperatures and pressures

✍ Scribed by James K. Tseng; Leonard I. Stiel

Publisher: American Institute of Chemical Engineers
Year: 1971
Tongue: English
Weight: 369 KB
Volume: 17
Category: Article
ISSN: 0001-1541
DOI: 10.1002/aic.690170604

No coin nor oath required. For personal study only.

✦ Synopsis

concentration of this certain component and relatively m a l l weights are used for the other components. Furthermore, instead of the least squares criterion, any other criterion can also be used in the procedure discussed above.

An estimation problem with multipoint boundary value

(3) in difference equations can also be solved by essentially the same approach. For example, it is frequently necessary to have a certain specified purity of a certain side stream. Since this side stream is located at a plate inside the column and not at the terminals, a multipoint boundary-value problem is formulated. Many other specifications of the conditions of a distillation column are possible ( 5 ) . As we shall see in later papers, the present approach has certain distinct advantages over the conventional procedures for some of the specifications.

It should be emphasized that the problem formulated does not always have solution. For example, the specified purity of the end product must be within the capability of the specified column in order for a solution to exist. The estimation approach avoids this problem. This is because of the fact that the least squares criterion only demands a solution that is as near as possible to the desired one.

📜 SIMILAR VOLUMES

Thermal Hydrogenolysis of Polyaromatic H

Thermal Hydrogenolysis of Polyaromatic Hydrocarbons and Activated Carbon at Elevated Temperatures and Pressures

✍ Mariusz K. Cieplik; Robert Louw; Wibo B. van Scheppingen 📂 Article 📅 2001 🏛 John Wiley and Sons 🌐 English ⚖ 391 KB 👁 2 views

Permeation of vapors through polymers at

Permeation of vapors through polymers at low temperature and elevated pressures

✍ Ernest J. Henley; Marcos Luiz Dos Santos 📂 Article 📅 1967 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 278 KB 👁 2 views

Experimental and theoretical investigati

Experimental and theoretical investigation of solubility and diffusion of ethylene in semicrystalline PE at elevated pressures and temperatures

✍ C. Kiparissides; V. Dimos; T. Boultouka; A. Anastasiadis; A. Chasiotis 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 212 KB 👁 1 views

Phase behavior and reaction of nylon 6/6

Phase behavior and reaction of nylon 6/6 in water at high temperatures and pressures

✍ R. L. Smith Jr.; Z. Fang; H. Inomata; K. Arai 📂 Article 📅 2000 🏛 John Wiley and Sons 🌐 English ⚖ 372 KB 👁 1 views

The phase behavior and reaction of nylon 6/6 in water were studied with a diamond anvil cell (DAC) technique and visual microscopy. Nylon 6/6 concentrations in water and cell temperatures were varied from 11 to 46% and from 264 to 425°C, respectively. The pressures studied ranged from 30 to 900 MPa.

Molecular weights of polyethylene and po

Molecular weights of polyethylene and polypropylene by vapor pressure osmometry at elevated temperatures

✍ J. W. Mays; E. G. Gregory 📂 Article 📅 1987 🏛 John Wiley and Sons 🌐 English ⚖ 244 KB 👁 2 views

The Wescan Model 232-A' VPO was modified with a 12 volt regulated power supply for supplying bridge current and with thermocouples to allow for direct digital readout of the syringe box and measuring chamber temperatures. The modified instrument was used to measure m,, of standard (NBS) polyethylene

Note: Autoignition Temperature of Select

Note: Autoignition Temperature of Selected Polymers at Elevated Oxygen Pressure and Their Heat of Combustion

✍ Fu-Yu Hshieh; Joel M. Stoltzfus; Harold D. Beeson 📂 Article 📅 1996 🏛 John Wiley and Sons 🌐 English ⚖ 375 KB 👁 2 views

Autoignition temperature and heat of combustion are two important parameters in determining the oxygen compatibility of materials. This study investigates the autoignition temperature of 32 polymers at an elevated oxygen pressure of 10.3 MPa and reports their heat of combustion.