✦ LIBER ✦

The machining of rolls surfaced with hard alloys

✍ Scribed by V. I. Merzlykov

Book ID: 112391475
Publisher: Springer US
Year: 1966
Tongue: English
Weight: 157 KB
Volume: 10
Category: Article
ISSN: 0026-0894
DOI: 10.1007/bf00736782

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Surfacing of rolls with hard alloys

✍ V. A. Sokolov; A. N. Novikov; P. M. Morozov 📂 Article 📅 1963 🏛 Springer US 🌐 English ⚖ 74 KB

Rolling contact fatigue life of finish h

Rolling contact fatigue life of finish hard machined surfaces: Part 1. Model development

✍ Youngsik Choi; C. Richard Liu 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 495 KB

This research presents a methodology for modeling the rolling contact fatigue life of finish hard machined surfaces. Part 1 of two companion papers presents the development of a life model; Part 2 presents an experimental verification of the life model. A crack initiation life model and a crack prop

Rolling contact fatigue life of finish h

Rolling contact fatigue life of finish hard machined surfaces: Part 2. Experimental verification

✍ Youngsik Choi; C. Richard Liu 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 486 KB

A rolling contact fatigue life model encompassing crack initiation life and crack propagation life was developed in Part 1 of two companion papers. This paper concerns the experimental verification of the developed life model. The specimens were machined by using various machining conditions and at

Physicomechanical state of the surface l

Physicomechanical state of the surface layer of hard-alloy parts after electrospark machining

✍ I. I. Mukhanov; V. N. Filimonenko; B. Kh. Pivovarov 📂 Article 📅 1973 🏛 Springer 🌐 English ⚖ 410 KB

Influence of tool flank wear on performa

Influence of tool flank wear on performance of finish hard machined surfaces in rolling contact

✍ Youngsik Choi 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 561 KB

This study investigates the influence of tool flank wear on the performance of finish hard machined surfaces in rolling contact. The residual stress and micro-hardness distribution below the machined surface and the surface roughness of the machined surface were measured to investigate the rolling c

Operation of blast-furnace valves hard-s

Operation of blast-furnace valves hard-surfaced with composite alloy

✍ I. V. Netesa; D. A. Dudko; B. I. Maksimovich; V. I. Komar 📂 Article 📅 1974 🏛 Springer US 🌐 English ⚖ 208 KB