✦ LIBER ✦

The influence of friction on the prediction of wrinkling of prestrained blanks when drawing through a conical die

✍ Scribed by R. Narayanasamy; C. Loganathan

Book ID: 108200682
Publisher: Elsevier Science
Year: 2007
Weight: 550 KB
Volume: 28
Category: Article
ISSN: 0261-3069
DOI: 10.1016/j.matdes.2005.10.018

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Wrinkling of sheet metals when drawing t

Wrinkling of sheet metals when drawing through a conical die

✍ R. Narayanasamy; R. Sowerby 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 656 KB

This paper deals with the deep drawing of circular blanks into cylindrical cups through a conical die using flat-bottomed and hemispherical-ended punches. It is well established that the use of a conical die can enhance the limiting drawing ratio compared with that obtainable in a conventional drawi

Effect of annealing on the wrinkling beh

Effect of annealing on the wrinkling behaviour of the commercial pure aluminium grades when drawn through a conical die

✍ C. Loganathan; R. Narayanasamy; S. Sathiyanarayanan 📂 Article 📅 2006 🏛 Elsevier Science ⚖ 133 KB

The drawing of a thin tube through a con

The drawing of a thin tube through a conical die

✍ V.V Sokolovskii 📂 Article 📅 1960 🏛 Elsevier Science 🌐 English ⚖ 246 KB

The effect of work-hardening on deep-dra

The effect of work-hardening on deep-drawing through a conical die

✍ A.H.M. Al-Mahdawie; P.B. Mellor 📂 Article 📅 1986 🏛 Elsevier Science ⚖ 388 KB

The manufacture of ultra-high modulus po

The manufacture of ultra-high modulus polyethylenes by drawing through a conical die

✍ A. G. Gibson; I. M. Ward 📂 Article 📅 1980 🏛 Springer 🌐 English ⚖ 655 KB

Calculations on the influence of frictio

Calculations on the influence of friction and die geometry in sheet drawing

✍ A.P. Green; R. Hill 📂 Article 📅 1952 🏛 Elsevier Science 🌐 English ⚖ 410 KB