๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

The influence of contact stress on the wear of UHMWPE for total replacement hip prostheses

โœ Scribed by P.S.M. Barbour; D.C. Barton; J. Fisher

Publisher
Elsevier Science
Year
1995
Tongue
English
Weight
992 KB
Volume
181-183
Category
Article
ISSN
0043-1648

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Wear simulation of UHMWPE for total hip
Wear simulation of UHMWPE for total hip replacement with a multidirectional motion pin-on-disk device: Effects of counterface material, contact area, and lubricant
โœ Saikko, Vesa ;Ahlroos, Tiina ๐Ÿ“‚ Article ๐Ÿ“… 2000 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 551 KB

The wear of nonirradiated ultra-high molecular weight polyethylene (UHMWPE) was studied with a circularly translating pin-on-disk (CTPOD) device. With this simple device, the wear of the acetabular cup is simulated. Two shapes of a polyethylene pin were used: flat wear faces of 3.0 and 8.9 mm in dia

The influence of wear paths produced by
The influence of wear paths produced by hip replacement patients during normal walking on wear rates
โœ Damien Bennett; Lee Humphreys; Seamus O'Brien; Connor Kelly; John Orr; David E. ๐Ÿ“‚ Article ๐Ÿ“… 2008 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 145 KB

## Abstract Variation in wear paths is known to greatly affect wear rates in vitro, with multidirectional paths producing much greater wear than unidirectional paths. This study investigated the relationship between multidirectional motion at the hip joint, as measured by aspect ratio, sliding dist

The influence of femoral head surface ro
The influence of femoral head surface roughness on the wear of ultrahigh molecular weight polyethylene sockets in cementless total hip replacement
โœ Elfick, Alistair P. D. ;Hall, Richard M. ;Pinder, Ian M. ;Unsworth, Anthony ๐Ÿ“‚ Article ๐Ÿ“… 1999 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 338 KB ๐Ÿ‘ 2 views

A theoretical relationship was recently proposed relating the wear behavior of polymetric bearing materials articulating against hard counterfaces. 1 This model attempts to predict the influence of surface roughness on wear. Laboratory-based studies have been used to establish the validity of these