## Abstract In recent years the requirement for the reduction of energy consumption has been increasing to solve the problems of global warming and the shortage of petroleum resources. For example, in the power generation field, as thermal power generation occupied 60% of the power generation deman
The heat transfer and pressure drop characteristics of the finned tube banks in forced convection (effects of fin height on heat transfer characteristics)
β Scribed by Kiyoshi Kawaguchi; Kenichi Okui; Toshihiro Asai; Yutaka Hasegawa
- Publisher
- John Wiley and Sons
- Year
- 2006
- Tongue
- English
- Weight
- 701 KB
- Volume
- 35
- Category
- Article
- ISSN
- 1099-2871
No coin nor oath required. For personal study only.
β¦ Synopsis
Abstract
In recent years the requirement for the reduction of energy consumption has been increasing to solve the problems of global warming and the shortage of petroleum resources. For example, in the power generation field, as thermal power generation occupies 60% of the power generation demand, considerable improvement of thermal efficiency is required. This paper describes the heat transfer characteristics of finned tube banks used for the heat exchanger in thermal power generation that were clarified by testing serrated finned tube banks with different fin heights for improved higher heat transfer and conventional spiral finned tube banks with different fin height. Then an equation to predict the heat transfer coefficient which is necessary for the design of the heat exchanger was proposed. Β© 2006 Wiley Periodicals, Inc. Heat Trans Asian Res, 35(3): 194β208, 2006; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/htj.20111
π SIMILAR VOLUMES
## Abstract Effect of fins on heat transfer around a tube was investigated experimentally. A test tube of 30 mm diameter was installed in a test section of an openβtype wind tunnel as a single tube, or as a center tube in a single tube row and in a tube bundle of staggered layout. Fins made of pape
## Abstract The fluid flows and heat transfer characteristics of a tube with internal longitudinal fins were investigated experimentally and numerically. The realizable turbulence model was adopted to simulate the problem, whose results indicate a good agreement with the measured data. Compared wit
## Abstract Pressure drop and heat transfer characteristics of air in three annular tubes with different internal longitudinal fins were investigated experimentally at uniform wall heat flux. The tested tubes have a doubleβpipe structure with the inner blocked tube as an insertion. Three different
## Abstract The effect of fins on heat transfer around a tube in an alignedβarranged tube bundle was investigated experimentally, and the obtained results were compared for three arrangements, i.e., single tube, single tube row, and staggeredβarrangement. It was found from the experiment that the e