✦ LIBER ✦

The effect of small additions of Zr, Cr, Mg, Al, and Si on the oxidation of 6∶4 brass

✍ Scribed by Dong-Bok Lee; Jae-Jin Moon

Publisher: TechnoPress
Year: 2002
Tongue: English
Weight: 443 KB
Volume: 8
Category: Article
ISSN: 1598-9623
DOI: 10.1007/bf03186103

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The effect of Al and Cr additions on pac

The effect of Al and Cr additions on pack cementation zinc coatings

✍ D. Chaliampalias; M. Papazoglou; S. Tsipas; E. Pavlidou; S. Skolianos; G. Stergi 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 637 KB

Low carbon steel (AISI St-32) plates were used as substrates. The chemical composition of the particular steel is presented in

Effect of Zr Addition on the High-Temper

Effect of Zr Addition on the High-Temperature Oxidation Behaviour of Mo–Si–B Alloys

✍ S. Burk; B. Gorr; V. B. Trindade; H.-J. Christ 📂 Article 📅 2009 🏛 Springer-Verlag 🌐 English ⚖ 629 KB

A TEM study of the combined effect of se

A TEM study of the combined effect of severe plastic deformation and (Zr), (Sc+Zr)-containing dispersoids on an Al–Mg–Si alloy

✍ M. Cabibbo; E. Evangelista 📂 Article 📅 2006 🏛 Springer 🌐 English ⚖ 722 KB

The Effect of Si Additions on the High-T

The Effect of Si Additions on the High-Temperature Oxidation of a Ternary Ni–10Cr–4Al Alloy in 1 ATM O2AT 900–1000

✍ S. Wang; Y. Wu; F. Gesmundo; Y. Niu 📂 Article 📅 2008 🏛 Springer-Verlag 🌐 English ⚖ 943 KB

The effect of additions of Mn and Cr and

The effect of additions of Mn and Cr and the applied solidification technique on the structure of an Al-2.2 at% Zn-1.4 at% Mg alloy

✍ Czurratis, P. ;Korngiebel, E. ;Löffler, H. ;Jacobi, G. 📂 Article 📅 1988 🏛 John Wiley and Sons 🌐 English ⚖ 897 KB

Stabilization Effect of Zr and Ti Additi

Stabilization Effect of Zr and Ti Additions on the Ageing Characteristics of Al-1 wt% Si Alloy Through a Creep Study

✍ Dr. G. H. Deaf; M. H. N. Beshai; A. M. Abd El Khalek; Prof. Dr. G. Graiss; Prof. 📂 Article 📅 1997 🏛 John Wiley and Sons 🌐 English ⚖ 446 KB 👁 1 views

Si-0.1 wt% Zr-0.1 wt% Ti alloys were used to trace the effect of Zr and Ti additions on the behaviour of the steady state creep. After solid solution treatment specimens of both alloys were aged at 623, 673, 723 and 773 K and creep tests were performed at room temperature by applying stresses of 60.