Micromechanics was used to show that the rupture strength of polymer-induced flocs varied with the hydrodynamic conditions at which the flocs were formed. A maximum floc strength at an intermediate shear rate was observed. The overall performance of the polymeric flocculants, as determined by two in
The Effect of Molecular Weight of Nonadsorbing Polymer on the Structure of Depletion-Induced Flocs
โ Scribed by Janine L. Burns; Yao-de Yan; Graeme J. Jameson; Simon Biggs
- Publisher
- Elsevier Science
- Year
- 2002
- Tongue
- English
- Weight
- 141 KB
- Volume
- 247
- Category
- Article
- ISSN
- 0021-9797
No coin nor oath required. For personal study only.
โฆ Synopsis
This work explores the structural compactness of depletion-induced particle flocs with respect to the molecular weight of nonadsorbing polymer flocculants. Small-angle static light scattering was used to monitor the structural characteristics of the flocs, which were formed by the addition of nonadsorbing poly(acrylic acids) to a stable colloidal polystyrene latex dispersion. It was found that the floc mass fractal dimension, considered to be a measure of structural compactness, was dependent upon both the molecular weight and the concentration of the polyacid. In particular, reducing the molecular weight of the polymer at a fixed polyacid concentration resulted in higher mass fractal dimensions, despite the highly polydisperse nature of the polymer samples. This structural behavior was attributed to the lower particle sticking efficiencies upon collision. This reduced sticking ability is the result of the shallowing in the secondary potential energy well with decreasing polymer chain length, which was directly supported by atomic force microscopy data. Our results suggest that the formation of a shallower attraction well with a lower molecular weight nonadsorbing polymer is the result of the insufficiency of the increased osmotic pressure to counter-balance the short-ranged nature of the depletion interaction.
๐ SIMILAR VOLUMES
Stable, polymer-coated nanoparticles of two hydrophobic drugs, namely nabumetone and halofantrine, have been prepared by a wet-bead milling process performed in the presence of a stabilizing homopolymer, either hydroxypropylmethylcellulose (HPMC) or polyvinylpyrrolidone (PVP), of differing molecular
The effect of impeller type and shear rate on the evolution of floc size and structure during shear-induced flocculation of polystyrene particles with aluminum sulfate is investigated by image analysis. One radial flow (six-blade Rushton turbine) and two axial flow (three-blade fluid foil, four-blad