𝔖 Bobbio Scriptorium
✦   LIBER   ✦

The effect of cement particle size distribution upon properties of pastes and mortars with low water-to-cement ratio

✍ Scribed by F. Škvára; K. Kolář; J. Novotný; Z. Zadák

Publisher
Elsevier Science
Year
1981
Tongue
English
Weight
510 KB
Volume
11
Category
Article
ISSN
0008-8846

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The effects of particle size distributio
The effects of particle size distribution and surface area upon cement strength development
✍ I.B. Celik 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 795 KB

Particle size distribution, uniformity of the distribution and specific surface area (SSA) have a great influence on service properties of cement, particularly on strength. In this paper the effects of these physical parameters on strength development were studied using PC 42.5 R. In order to unders

The effect of particle size distribution
The effect of particle size distribution on the properties of blended cements incorporating GGBFS and natural pozzolan (NP)
✍ Hanifi Binici; Orhan Aksogan; Ismail H. Cagatay; Mustafa Tokyay; Engin Emsen 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 497 KB

This paper investigates the effect of particle size distribution on the properties of blended cements incorporating ground granulated blastfurnace slag (GGBFS) and natural pozzolan (NP). Pure Portland cement (PPC), NP and GGBFS were used to obtain blended cements that contain 10, 20, 30% additives.

Cement pastes of low water to solid rati
Cement pastes of low water to solid ratio: An investigation of the porosity characteristics under the influence of a superplasticizer and silica fume
✍ A. /kDureković 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 622 KB

were prepared using an ordinary portland cement in which 0-5-10 and 15 per cent of weight was replaced by condensed silica fume (CSF). Solvent exchange treatment and vacuum drying of samples were carried out before the use of the mercury intrusion technique. Capillary water suction (CWS) and the por

Cement pastes of low water to solid rati
Cement pastes of low water to solid ratio: An investigation of the polymerization of silicate anions in the presence of a superplasticizer and silica fume
✍ A. Durekovic; B. Tkalcic-Ciboci 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 520 KB

Polymerization of silicate anions was investigated by the molybdate method in cement pastes with water to solid ratio of 0.28. Two series of samples -with and without superplasticizer admixture -were prepared using ordinary portland cement (OPC) in which 0, 5, 10, and 15 percent by weight was replac