✦ LIBER ✦

The effect of artificial surface roughness on heat and momentum transfer

✍ Scribed by D. W. Savage; J. E. Myers

Publisher: American Institute of Chemical Engineers
Year: 1963
Tongue: English
Weight: 949 KB
Volume: 9
Category: Article
ISSN: 0001-1541
DOI: 10.1002/aic.690090523

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Effect of wall roughness on convective h

Effect of wall roughness on convective heat transfer in commercial pipes

✍ J. W. Smith; Norman Epstein 📂 Article 📅 1957 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 658 KB

Effect of bed surface roughness on longi

Effect of bed surface roughness on longitudinal dispersion in artificial open channels

✍ Marcus Schulz; Jan Priegnitz; Jörg Klasmeier; Stefan Heller; Stefan Meinecke; Mi 📂 Article 📅 2011 🏛 John Wiley and Sons 🌐 English ⚖ 444 KB

## Abstract In several empirical and modelling studies on river hydraulics, dispersion was negatively correlated to surface roughness. In this study, it was aimed to investigate the influence of surface roughness on longitudinal dispersion under controlled conditions. In artificial flow channels wi

The effect of surface tension on factors

The effect of surface tension on factors in boiling heat transfer

✍ John B. Roll; John E. Myers 📂 Article 📅 1964 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 563 KB

The effects of superheat and surface rou

The effects of superheat and surface roughness on boiling coefficients

✍ H. M. Kurihara; J. E. Myers 📂 Article 📅 1960 🏛 American Institute of Chemical Engineers 🌐 English ⚖ 936 KB

The effect of roughness configuration on

The effect of roughness configuration on velocity profiles in an artificial channel

✍ Wohl, Ellen E.; Ikeda, Hiroshi 📂 Article 📅 1998 🏛 John Wiley and Sons 🌐 English ⚖ 254 KB 👁 2 views

In order to determine the effect of bed roughness on velocity distribution, we used seven different configurations of bed roughness, with 16 test runs of varying discharge and slope for each configuration. For each run, one-dimensional velocity profiles were measured at 1cm vertical increments over

The effect of different surface morpholo

The effect of different surface morphology and roughness on osteoblast-like cells

✍ Michael Ball; David M. Grant; Wei-Jen Lo; Colin A. Scotchford 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 English ⚖ 449 KB 👁 1 views

## Abstract Increased magnitude of biomaterial surface roughness and micromachined‐grooved surfaces has both been shown to stimulate osteoblast activity, but have not been compared in the same study quantitatively. A series of titanium alloy (Ti6Al4V) samples were prepared using simple machining te