✦ LIBER ✦

The developing heat transfer and fluid flow in micro-channel heat sink with viscous heating effect

✍ Scribed by Dorin Lelea; Adrian Eugen Cioabla

Publisher: Springer-Verlag
Year: 2011
Tongue: English
Weight: 658 KB
Volume: 47
Category: Article
ISSN: 1432-1181
DOI: 10.1007/s00231-010-0751-y

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Three-dimensional analysis of fluid flow

Three-dimensional analysis of fluid flow and heat transfer in single- and two-layered micro-channel heat sinks

✍ M. L.-J. Levac; H. M. Soliman; S. J. Ormiston 📂 Article 📅 2011 🏛 Springer-Verlag 🌐 English ⚖ 528 KB

The heat transfer and fluid flow of a pa

The heat transfer and fluid flow of a partially heated microchannel heat sink

✍ Dorin Lelea 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 624 KB

Numerical modeling of the conjugate heat transfer in microchannel heat sink is presented. As the most of the cooling applications deals with the partial heated sections, the influence of the heating position on the thermal and hydrodynamic behavior is analyzed. The laminar fluid flow regime and the

Flow boiling heat transfer in two-phase

Flow boiling heat transfer in two-phase micro-channel heat sinks––II. Annular two-phase flow model

✍ Weilin Qu; Issam Mudawar 📂 Article 📅 2003 🏛 Elsevier Science 🌐 English ⚖ 244 KB

This paper is Part II of a two-part study devoted to measurement and prediction of the saturated flow boiling heat transfer coefficient in water-cooled micro-channel heat sinks. Part I discussed the experimental findings from the study, and identified unique aspects of flow boiling in micro-channels

Study on the convective heat transfer an

Study on the convective heat transfer and pressure drop in the micro-channel heat sink

✍ Paisarn Naphon; Osod Khonseur 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 694 KB

Experiments have been performed to investigate the heat transfer characteristics and pressure drop in the micro-channel heat sinks under constant heat flux conditions. The experiments are performed for the Reynolds number and heat flux in the ranges of 200-1000 and 1.80-5.40 kW/m 2 , respectively. T

Heat and mass transfer in a visco–elasti

Heat and mass transfer in a visco–elastic fluid flow over an accelerating surface with heat source/sink and viscous dissipation

✍ R. M. Sonth; S. K. Khan; M. S. Abel; K. V. Prasad 📂 Article 📅 2002 🏛 Springer-Verlag 🌐 English ⚖ 179 KB

Flow boiling heat transfer in two-phase

Flow boiling heat transfer in two-phase micro-channel heat sinks––I. Experimental investigation and assessment of correlation methods

✍ Weilin Qu; Issam Mudawar 📂 Article 📅 2003 🏛 Elsevier Science 🌐 English ⚖ 413 KB

This paper is the first of a two-part study concerning measurement and prediction of saturated flow boiling heat transfer in a water-cooled micro-channel heat sink. In this paper, new experimental results are discussed which provide new physical insight into the unique nature of flow boiling in narr