✦ LIBER ✦

The cutting process, chips, and cutting forces in machining CFRP

✍ Scribed by A. Koplev; Aa. Lystrup; T. Vorm

Book ID: 115836424
Publisher: Elsevier Science
Year: 1983
Weight: 706 KB
Volume: 14
Category: Article
ISSN: 0010-4361
DOI: 10.1016/0010-4361(83)90157-x

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Prediction of cutting forces and chip ge

Prediction of cutting forces and chip geometry in oblique machining from flow stress properties and cutting conditions

✍ G.C.I. Lin 📂 Article 📅 1978 🏛 Elsevier Science ⚖ 565 KB

Characteristics of cutting forces and ch

Characteristics of cutting forces and chip formation in machining of titanium alloys

✍ S. Sun; M. Brandt; M.S. Dargusch 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 991 KB

Friction and cutting forces in cryogenic

Friction and cutting forces in cryogenic machining of Ti–6Al–4V

✍ Shane Y Hong; Yucheng Ding; Woo-cheol Jeong 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 325 KB

Conventional cutting fluid serves both as a coolant and lubricant. In cryogenic machining, liquid nitrogen (LN2) is recognized as an effective coolant due to its low temperature; however, its lubrication properties are not well known. The focus of this study was to investigate how the friction betwe

Prediction of cutting forces in mill tur

Prediction of cutting forces in mill turning through process simulation using a five-axis machining center

✍ Joel Martins Crichigno Filho 📂 Article 📅 2011 🏛 Springer 🌐 English ⚖ 804 KB

The influence of the specific cutting fo

The influence of the specific cutting force and cross-sectional geometry of a chip on the cutting force in the process of circular rip-sawing

✍ B. Buc✓ar; D. G. Buc✓ar 📂 Article 📅 2002 🏛 Springer-Verlag 🌐 English ⚖ 131 KB

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process

✍ Ching-Chih Tai; Kuang-Hua Fuh 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 974 KB