The critical state model parameters of polycrystalline YBa2Cu3O7: Critical current in thin slabs and field penetration in hollow cylinders
โ Scribed by P. Fournier; M. Aubin
- Publisher
- Elsevier Science
- Year
- 1994
- Tongue
- English
- Weight
- 148 KB
- Volume
- 235-240
- Category
- Article
- ISSN
- 0921-4534
No coin nor oath required. For personal study only.
โฆ Synopsis
We compare the parameters of the Generalized Critical State Model used to reproduce data obtained from two independent measurements for polycrystalline YBa2Cu307 : the critical current of a thin slab and the central field in a hollow cylinder, both as a function of applied magnetic field and temperature. We observe a good correspondence between the parameters obtained from thin slabs (critical current) and the ones from hollow cylinders (central field). The temperature dependences of these parameters allow one to relate them to some important features of the microstructure : mean grain radius, relative orientation of the grains. The influence of the intergrain lower critical field is also considered.
๐ SIMILAR VOLUMES
A detailed discussion of the influence of the rotation of Ag-YBa2Cu307 wires about their longitudinal axis in an external magnetic field on the critical current value is presented. In particular the angular dependence of the local field, defined as a superposition of the trapped flux and the externa
The effect of different doses of ฮณ-rays on the behavior of the critical current density, J c in an YBa 2 Cu 3 O 7 polycrystalline sample has been investigated at high temperatures. The samples were irradiated at room temperature by a 60 Co ฮณ-ray source at a dose rate of 0.5 MR/h. J c was found to in
A study has been made of the cnt=cal current m silver clad YBa2Cu307 wires Detailed res=stwe trans,tlons, m zero magnetic field and w=th a magnet=c field apphed, indicate that below 10-3V m-1 these mater=als d~splay clear power law behawour of the form E=kl n w=th n values up to about 16 Th=s charac