✦ LIBER ✦

The calculation of heat capacity curves and phase diagrams based on regular solution theory

✍ Scribed by P. Garidel; C. Johann; A. Blume

Publisher: Springer Netherlands
Year: 2005
Tongue: English
Weight: 575 KB
Volume: 82
Category: Article
ISSN: 0022-5215
DOI: 10.1007/s10973-005-0916-y

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Correlation of the volumes and heat capa

Correlation of the volumes and heat capacities of solutions with their solid-liquid phase diagrams

✍ Gérald Perron; Lorraine Couture; Jacques E. Desnoyers 📂 Article 📅 1992 🏛 Springer US 🌐 English ⚖ 482 KB

Vibrational states and phase diagram of

Vibrational states and phase diagram of the submonolayer krypton adsorbed on graphite by the low temperature heat capacity

✍ Tatsuya Shirakami; Akira Inaba; Hideaki Chihara 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 376 KB

One- and two-phase isochoric heat capaci

One- and two-phase isochoric heat capacity measurements of aqueous solution of nacl near the critical point of pure water

✍ Ilmutdin M. Abdulagatov; Vasilii I. Dvoryanchikov; Abdurakhman N. Kamalov; Elena 📂 Article 📅 2000 🏛 John Wiley and Sons 🌐 English ⚖ 871 KB

The phase diagram of the water-hydrogen

The phase diagram of the water-hydrogen system in the crystallization field of solid solutions based on ices Ih and II at high pressures

✍ Yu. A. Dyadin; E. Ya. Aladko 📂 Article 📅 1995 🏛 Springer Netherlands 🌐 English ⚖ 321 KB

Phase Diagram for a System of Polydisper

Phase Diagram for a System of Polydisperse Components Consisting of the Precursor of an Epoxy/Diamine Thermoset and a Thermoplastic: Analysis Based on a Lattice Theory Model

✍ Maite Rico; Carmen Ramírez; Belén Montero; Javier Díez; Joaquín López 📂 Article 📅 2006 🏛 John Wiley and Sons 🌐 English ⚖ 193 KB

## Abstract **Summary:** The miscibility of a thermoplastic modifier with the precursors of an epoxy/diamine thermoset without chemical reaction was studied thermodynamically. The experimental cloud point curve showed a UCST behavior. A model based on the Flory‐Huggins lattice theory and on the Kon

Prediction and control of microstructure

Prediction and control of microstructure evolution for sub-microscale α-Al2O3 during low-heating-rate sintering based on the master sintering curve theory

✍ W.Q. Shao; S.O. Chen; D. Li; H.S. Cao; Y.C. Zhang; S.S. Zhang 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 279 KB

The master sintering curve (MSC) can sometimes be used for analyzing the shrinkage behaviour of ceramics. Densification of ␣-Al 2 O 3 with the mean particle size of 350 nm was continuously recorded during heating at 0.5, 2 and 5 • C/min. A MSC was successfully constructed using dilatometry data with