✦ LIBER ✦

Tests of bond resistance between concrete and steel

✍ Scribed by W.A. Slater; F.E. Richart; G.G. Scofield

Publisher: Elsevier Science
Year: 1920
Tongue: English
Weight: 138 KB
Volume: 190
Category: Article
ISSN: 0016-0032
DOI: 10.1016/s0016-0032(20)90079-0

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The bond resistance between steel and li

The bond resistance between steel and lightweight-aggregate (Lytag) concrete

✍ C.O. Orangun 📂 Article 📅 1967 🏛 Elsevier Science ⚖ 700 KB

Pull-out and bond beam test results on bond res&tance between lightweightaggregate (Lytag) concrete and steel are reported. It is shown that except at later stages of loading, square twisted bat's show better resistance to slip than either mild steel or Tentor bars. The average bond stresses obtaine

Linear correlation of bond strength and

Linear correlation of bond strength and contact electrical resistivity between steel rebar and concrete

✍ Xuli Fu; D.D.L. Chung 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 364 KB

The bond strength and contact electrical resistivity between steel rebar and concrete were found to be linearly related, due to an interfacial phase of high volume resistivity that helps the bonding. Acetone washing of the rebar increases the bond strength slightly and decreases the contact resistiv

Bond between prestressed steel and concr

Bond between prestressed steel and concrete—computer analysis using ADINA

✍ M.K. Euser; G. Mehlhorn; V. Cornelius 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 703 KB

Modelling the bond between concrete and

Modelling the bond between concrete and reinforcing steel in a fire

✍ Zhaohui Huang 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 908 KB

A non-linear procedure is presented for modelling the bond characteristic between concrete and reinforcing steel for reinforced concrete structures in a fire. The accuracy and reliability of the model are demonstrated by the analysis of one pull-out test and one beam test at ambient temperature and

Testing and analysis of steel-concrete-s

Testing and analysis of steel-concrete-steel sandwich beams

✍ T.M. Roberts; D.N. Edwards; R. Narayanan 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 902 KB

Bond characterization between concrete s

Bond characterization between concrete substrate and repairing SFRC using pull-off testing

✍ Everaldo Bonaldo; Joaquim A.O. Barros; Paulo B. Lourenço 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 894 KB

In the last years, an emerging repair and strengthening technique for concrete slabs has been used, consisting of applying a thin layer of steel fibre reinforced concrete (SFRC) onto the slabs. The performance of the strengthened structural system depends on the bonding behaviour between old and new