Information on moisture distribution patterns under point-source trickle emitters is a pre-requisite for the design and operation of trickle-irrigation systems. The distribution pattern is in#uenced by the soil properties and the manner water is applied and withdrawn from the soil pro"le. Flow from
SW—Soil and Water: Response to comment
✍ Scribed by J.Y. Diiwu; R.P. Rudra; W.T. Dickinson; G.J. Wall
- Publisher
- Elsevier Science
- Year
- 2000
- Tongue
- English
- Weight
- 108 KB
- Volume
- 77
- Category
- Article
- ISSN
- 0021-8634
No coin nor oath required. For personal study only.
📜 SIMILAR VOLUMES
A series of stress histories were detected successfully by plate explosive impact, using piezoelectric crystal gauges pre-positioned at di!erent depths of clayey and sandy soils. The soil dynamic constitutive relation was obtained from the measured stress histories, by "tting a stress}depth}time sur
The objectives of this study are to observe soil, nitrogen and phosphorus losses under di!erent amounts of fertilizer during the typhoon of 20 June 1997, and to evaluate the e!ects of soil and nutrient losses associated with the typhoon on the annual loads. Cumulative rainfall of 143)5 mm was record
This work presents a model based on the on-farm irrigation scheduling and the simulated annealing (SA) optimization method for agricultural water resource management. The proposed model is applied to an irrigation project located in Delta, Utah of 394)6 ha area for optimizing economic pro"ts, simula
Subsurface hydrographs, obtained during rainfall simulation on 1 m by 1 m plots, were separated into macropore and micropore components by application of a dual-porosity concept and mass balance analysis. The corresponding solute concentrations in the two domains were also determined by mass balance
A response surface methodology which employs an orthogonal regression technique and a third-order correction was used to determine in situ engineering properties of an untilled and a tilled Yolo loam soil. The technique employed an elasto-plastic constitutive material model for soil with Drucker Pra