𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Studies on γ-Fe2O3–high-density polyethylene composites and their additives

✍ Scribed by B. Govindaraj; N. V. Sastry; A. Venkataraman

Publisher
John Wiley and Sons
Year
2004
Tongue
English
Weight
133 KB
Volume
92
Category
Article
ISSN
0021-8995

No coin nor oath required. For personal study only.

✦ Synopsis

Abstract

γ‐Fe~2~O~3~–high‐density polyethylene (HDPE) composite films are prepared by a gel‐casting technique. To understand the effect of additives, rice husk ash and thiourea are made to disperse in the HDPE matrix to obtain the composite films with additives. The as‐prepared γ‐Fe~2~O~3~–HDPE composite films with their additives are subjected to characterization and study through X‐ray diffraction, thermal, scanning electron microscopy, and dielectric measurements. The results are qualitatively treated. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 92: 1527–1533, 2004

📜 SIMILAR VOLUMES

Thermal and morphological studies on γ-F
Thermal and morphological studies on γ-Fe2O3 polystyrene composites and the affect of additives
✍ B. Govindaraj; N. V. Sastry; A. Venkataraman 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 317 KB 👁 1 views

## Abstract γ‐Fe~2~O~3~polystyrene (PS) composite films were prepared by a gel‐casting technique to obtain monodisperse composite films. To understand the effect of additives on the prepared composite films, additives such as rice husk ash and thiourea were made to disperse into the PS matrix. The

Development of environmentally friendly
Development of environmentally friendly high-density polyethylene and turmeric spent composites: Physicomechanical, thermal, and morphological studies
✍ Murtuza Ali Syed; B. Ramaraj; Sania Akhtar; Akheel Ahmed Syed 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 234 KB

## Abstract High‐density polyethylene (HDPE)/turmeric spent (TS) composites were prepared by the extrusion of an HDPE resin with 5, 10, 15, or 20 wt % TS. HDPE granules and TS master‐batch flakes were compounded on a corotating and intermeshing twin‐screw extruder. The extrudate strands were cut in