✦ LIBER ✦

Structure and phase composition of Fe3Al alloy powder prepared by milling

✍ Scribed by T. Žák; O. Schneeweiss; Z. Čochnář; A. Buchal

Publisher: Elsevier Science
Year: 1991
Tongue: English
Weight: 577 KB
Volume: 141
Category: Article
ISSN: 0921-5093
DOI: 10.1016/0921-5093(91)90710-5

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Structure and phase composition of compl

Structure and phase composition of complexly alloyed powdered niobium containing nickel alloys

✍ L. E. Popova; V. I. Shvarts; V. F. Kotov; R. V. Lapina; G. B. Zvereva; T. V. Kos 📂 Article 📅 1988 🏛 Springer 🌐 English ⚖ 491 KB

Effect of composition on the formability

Effect of composition on the formability of quasicrystalline phase in mechanically alloyed Al–Cu–Fe powders

✍ Shilong Yin; Caixia Li; Qing Blan; Min Lu 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 459 KB

Features of the structure of powder and

Features of the structure of powder and coatings of Fe-C-Si-Al alloy

✍ V. E. Oliker; I. E. Polishchuk; A. F. Zhornyak; V. V. Voitovich 📂 Article 📅 1988 🏛 Springer 🌐 English ⚖ 1022 KB

Amorphous phase in SiCp/2024 composite p

Amorphous phase in SiCp/2024 composite prepared by detonation-gaseous spraying of mechanically alloyed powders

✍ Che Chengwei; Xie Zizhang; Yang Rang; Zhao Qing 📂 Article 📅 1995 🏛 Springer 🌐 English ⚖ 809 KB

Preparation of γ-Fe2O3-Fe2O3ultrafine po

Preparation of γ-Fe2O3-Fe2O3ultrafine powders by laser vapour-phase reaction

✍ Xinyong Li; Enhui Lin; Changyan Zhang; Shuben Li 📂 Article 📅 1995 🏛 Springer 🌐 English ⚖ 447 KB

Preparation and mechanical properties of

Preparation and mechanical properties of Fe3Al(Ti)/TiC composites

✍ Jia Li; Qiang Liu; Rui-xia Shi; Yu Wen; Yan-sheng Yin 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 797 KB

Near fully dense Fe 3 Al(10Ti)/TiC composites were synthesized by MA and hot-pressing sintering methods. Based on the Orowan strengthening effect offered by the nano-TiC particles, higher three-point bending strength and hardness values, 1310 MPa and 90 HRA, were achieved in Fe 3 Al(10Ti)/40 vol%TiC