The objective of this study was to evaluate the influence of silica fume on the hydration heat of concrete. Portland cement was replaced by silica fume in amounts from 10 % to 30 % by mass in concrete with w/(c+sf) ratios varying between 0.25 and 0.45. A superplasticizer was used to maintain a fluid
Structural shear behaviour of recycled concrete with silica fume
✍ Scribed by Belén González-Fonteboa; Fernando Martínez-Abella; Isabel Martínez-Lage; Javier Eiras-López
- Publisher
- Elsevier Science
- Year
- 2009
- Tongue
- English
- Weight
- 529 KB
- Volume
- 23
- Category
- Article
- ISSN
- 0950-0618
No coin nor oath required. For personal study only.
✦ Synopsis
This paper is the outcome of the second stage of studies carried out on the structural behaviour of recycled concrete. The first stage determined, using beams specimens, the shear behaviour of recycled concrete with which 50% of the coarse aggregate was replaced by recycled coarse aggregate (obtained from concrete demolition waste). This stage revealed minor differences (recycled concrete -conventional concrete) in ultimate loads and these differences were found to increase when cracking was taken into account. In this study, it was determined that the addition of 8% silica fume to recycled concrete (recycled concrete with silica fume) improved this behaviour. Moreover, the use of this material in recycled concrete produced changes in its structural behaviour similar to those induced in conventional concrete (conventional concrete with silica fume). Finally, experimental results were compared using current codes and it had been seen that all of them were conservative so t can be used for the shear design of recycled concrete beams with silica fume.
📜 SIMILAR VOLUMES
The concept of using recycled aggregate for making concrete is slowly but definitely gaining popularity. Research is in progress to make this technology feasible. The results of the present investigation, reported here, is one such attempt. The basic objective of the present study, is to attain acce
In this study, the mechanical and physical properties of concrete specimens obtained by substituting cement with finely ground pumice (FGP) at proportions of 5%, 10%, 15% and 20% by weight has been investigated, in addition to analyzing the corrosion behavior of reinforcing steels embedded in these