Stress corrosion cracking behaviour of Al-Li alloy 8090-T8171 plate exposed to various synthetic environments
✍ Scribed by R. Braun
- Publisher
- John Wiley and Sons
- Year
- 2004
- Tongue
- German
- Weight
- 364 KB
- Volume
- 55
- Category
- Article
- ISSN
- 0947-5117
No coin nor oath required. For personal study only.
✦ Synopsis
The stress corrosion cracking (SCC) behaviour of 8090-T8171 plate material was investigated in short transverse direction performing constant load tests and constant extension rate tests under permanent immersion conditions. At an applied stress of 100 MPa, smooth round tensile specimens were exposed to synthetic environments containing chlorides and various nonhalide anions. Environment-induced cracking was not observed in aqueous solutions of 0.6 M NaCl, LiCl, NH 4 Cl, or MgCl 2 . In 0.6 M NaCl solutions containing 0.06 M Na 2 SO 4 or Na 3 PO 4 , the SCC behaviour of 8090-T8171 plate was similar to that observed in pure 0.6 M NaCl solution. Sodium chloride solutions with additions of nitrate, hydrogen carbonate, or carbonate promoted stress corrosion cracking. Threshold stresses below 100 MPa were obtained from constant load tests using the latter environments. When sodium sulfite or sodium hydrogen phosphate was added, values being 100 MPa or slightly higher were determined. Lithium and ammonium present as cations in mixed salt electrolytes accelerated SCC failure. Lithium chloride solutions containing nitrate, hydrogen carbonate, carbonate, or sulfite were highly conducive to stress corrosion cracking. Very low SCC resistance was found for alloy 8090-T8171 exposed to synthetic environments with additions of ammonium salts. Constant extension rate tests were carried out using notched tensile specimens. Displacement rates were in the range 2 Â 10 À6 À 2 Â 10 À5 mms À1 . Aqueous 0.6 M NaCl solutions with additions of 0.06 M NH 4 HCO 3 , (NH 4 ) 2 SO 4 , or Li 2 CO 3 promoted environment-induced cracking with 8090-T8171 plate, as indicated by severe degradation of notch strength. The constant extension rate testing technique did not indicate SCC susceptibility using sodium chloride solutions containing sodium sulfate or lithium sulfate. For specimens exposed to substitute ocean water a slight degradation of notch strength was found at the lowest displacement rate applied.