## Abstract The Mechanical properties of injection molded and compression molded graphite fiberβreinforced polypropylenes are discussed. In general, the tensile properties of polypropylene are significantly improved by reinforcement with graphite fibers and to a greater extent than achieved by glas
Strength improvement of short graphite fiber-reinforced polypropylene
β Scribed by R. A. Weiss
- Publisher
- Society for Plastic Engineers
- Year
- 1981
- Tongue
- English
- Weight
- 569 KB
- Volume
- 2
- Category
- Article
- ISSN
- 0272-8397
No coin nor oath required. For personal study only.
β¦ Synopsis
Abstract
The Improvement of the tensile strength of discontinuous graphite fiberβreinforced polypropylene is described. Two methods were employed: (1) modification of the polymer backbone by the introduction of acrylic acid grafts and (2) varying the chemistry of the fiber sizing. The strength improvements attained are attributed to intermolecular interactions, such as hydrogen bonding, which improve the adhesion between the fiber and the polymer.
π SIMILAR VOLUMES
Jute fibers were chopped to approximately 100 mm in length and then processed through a granulator having an 8-mm screen. Final fiber lengths were up to 10 mm maximum. These fibers along with polypropylene granules and a compatibilizer were mixed in a K-mixer at a fixed rpm, 5500, and dumped at a fi
Short jute fiber-reinforced polypropylene (PP) composites were prepared using a high-speed thermokinetic mixer. A compatibilizer was used to improve the molecular interaction between jute and PP. Both the percent weight fraction of the jute fiber and compatibilizer were varied to study the dynamic m