✦ LIBER ✦

Steels for side members of truck frames

✍ Scribed by Yu. F. Chechekin; M. A. Tylkin; N. S. Strukova; K. A. Nabatova

Book ID: 112381473
Publisher: Springer US
Year: 1968
Tongue: English
Weight: 232 KB
Volume: 10
Category: Article
ISSN: 0026-0673
DOI: 10.1007/bf00649371

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Steel for truck side members

✍ V. N. Marchenko; D. A. Litvinenko; G. V. Levchenko; V. V. Medvedev; I. T. Usikov 📂 Article 📅 1981 🏛 Springer US 🌐 English ⚖ 292 KB

Heat treatment of quality low-alloy stee

Heat treatment of quality low-alloy steels for KamAZ truck side members

✍ A. V. Tyukov; B. A. Fel'dman; P. M. Mikhalev 📂 Article 📅 1987 🏛 Springer US 🌐 English ⚖ 135 KB

Optimum design of steel frames with tape

Optimum design of steel frames with tapered members

✍ M.P. Saka 📂 Article 📅 1997 🏛 Elsevier Science 🌐 English ⚖ 990 KB

The design of steel tapered members for combined axial and flexural strength is somewhat complex and tedious if no approximation is made. However, recent load and resistance factor design (LRFD) of the AISC code has treated the problem with sufficient accuracy and ease. In this study, an algorithm i

Efficient computation of buckling loads

Efficient computation of buckling loads for plane steel frames with tapered members

✍ Nikitas Bazeos; Dimitris L. Karabalis 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 618 KB

An approximate method for quick calculation of the critical load of tapered columns is proposed. The method is based on a series of dimensionless design-oriented charts relating the critical load of linearly tapered columns of I-section to the taper ratio and boundary conditions. These charts are de

Improving the technology used to make st

Improving the technology used to make steel for side members

✍ V. V. Pavlov; E. K. Shafigin; E. M. Kolomiets; L. M. Kulakova 📂 Article 📅 2000 🏛 Springer US 🌐 English ⚖ 280 KB

Behaviour of thin steel plate shear wall

Behaviour of thin steel plate shear walls regarding frame members

✍ M.M. Alinia; M. Dastfan 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 1004 KB

Steel plate shear walls in buildings are known to be an effective and strong means for resisting lateral forces. The view of some structural designers is to use heavy stiffeners to reinforce and increase the buckling capacity of shear walls; whereas, if the walls are left unstiffened and allowed to