𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Stability considerations for design of a high temperature superconductor

✍ Scribed by A. Abeln; E. Klemt; H. Reiss

Publisher
Elsevier Science
Year
1992
Tongue
English
Weight
952 KB
Volume
32
Category
Article
ISSN
0011-2275

No coin nor oath required. For personal study only.

✦ Synopsis

Predictions based on the well known cryogenic stability criterion for the permissible ratio J/Jc of transport to critical current density of high Tc superconductors are compared with a transient analysis. The results demonstrate that calculation of the transient 'temperature history' of the superconductor after a thermal disturbance, as well as knowledge of the magnitude of this disturbance, is necessary when designing a conductor for a particular application. While in other published work on stability analysis, constant heat transfer coefficients were applied, an analysis like the one presented here allows one to calculate more accurately heat transfer by using the transient temperature difference between superconductor and coolant.

πŸ“œ SIMILAR VOLUMES

Design considerations for high Tc cerami
Design considerations for high Tc ceramic superconductors
✍ E.W Collings πŸ“‚ Article πŸ“… 1988 πŸ› Elsevier Science 🌐 English βš– 969 KB

The flux-jump stabdlty and cryostabdlty of model conductors based on the ceramic superconductor YBa2Cu307 (YBC) are considered The higher specific heat of materials at 80 K than at 4 K guarantees a much greater admbat=c flux-jump stabdlty In fact, YBC should be ~mmune to admbatic flux jumping =n app

Temperature stabilized sample stage for
Temperature stabilized sample stage for the investigation of high Tc superconductors by scanning electron microscopy
✍ R Gross; J Bosch; H.-G Wener; J Fischer; R.P Huebener πŸ“‚ Article πŸ“… 1989 πŸ› Elsevier Science 🌐 English βš– 491 KB

A cryogenic sample stage for scanning electron microscopes is described. The setup allows performance of measurements in the temperature range from 1.5 K to 300 K. During the measurements the sample can be irradiated directly by the electron beam. The sample temperature can be stabilized by a temper

Predictions of pressure-induced transiti
Predictions of pressure-induced transition temperature increase for a variety of high-temperature superconductors
✍ Mario Rabinowitz; T. McMullen πŸ“‚ Article πŸ“… 1994 πŸ› Elsevier Science 🌐 English βš– 231 KB

A wide variety of superconducting oxides are used to test a general model of high-pressure-induced transition temperature (To) changes. The Tc vary from a low of 24 K to a high of 164 K. Although the model is capable of predicting both increases and decreases in Tc with pressure, only superconductor

Use of high temperature superconductor i
Use of high temperature superconductor in a receiver coil for magnetic resonance imaging
✍ A. S. Hall; N. Mcn. Alford; T. W. Button; D. J. Gilderdale; K. A. Gehring; I. R. πŸ“‚ Article πŸ“… 1991 πŸ› John Wiley and Sons 🌐 English βš– 266 KB πŸ‘ 1 views

## Abstract A planar YBa~2~Cu~3~O~x~ (YBCO) coil has been used as a pick‐up coil in a nuclear magnetic resonance imager. It was found that the quality factor __Q__ of the YBCO coil was greater than its copper counterpart by approaching 50% even in a field of 0.15 T. The Q of the copper coil at 77 K