✦ LIBER ✦

Stability analysis of chatter vibration in turning processes

✍ Scribed by M. Rahman; Y. Ito

Publisher: Elsevier Science
Year: 1985
Tongue: English
Weight: 504 KB
Volume: 102
Category: Article
ISSN: 0022-460X
DOI: 10.1016/s0022-460x(85)80111-5

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Analysis of tool wear effect on chatter

Analysis of tool wear effect on chatter stability in turning

✍ Y.S Chiou; E.S Chung; S.Y Liang 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 813 KB

Numerical simulation of non-linear chatt

Numerical simulation of non-linear chatter vibration in turning

✍ Krzysztof Jemielniak; Adam Widota 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 438 KB

Analysis of chatter vibration in the end

Analysis of chatter vibration in the end milling process

✍ An-Chen Lee; Chia-Shang Liu 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 416 KB

Nonlinear behaviour of the regenerative

Nonlinear behaviour of the regenerative chatter in turning process with a worn tool: Forced oscillation and stability analysis

✍ Hamed Moradi; Firooz Bakhtiari-Nejad; Mohammad R. Movahhedy; Mohammad T. Ahmadia 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 911 KB

Stability analysis of chatter vibration

Stability analysis of chatter vibration for a thin-wall cylindrical workpiece

✍ G.J. Lai; J.Y. Chang 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 778 KB

AlmtnctmTbe vibration characteristics and the vibration direction angle between the beam mode and shell mode of the three-jaw clamped thin.wall cylindrical workpiece will change accordin 8 to the relative position of the cutting tool to the chucking jaws. This will induce parametric vibration and ca

Chatter, process damping, and chip segme

Chatter, process damping, and chip segmentation in turning: A signal processing approach

✍ Christopher M Taylor; Sam Turner; Neil D Sims 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 788 KB