Acoustic &&breakout'' and &&breakin'' through duct walls had, until the late 1970s, been a rather neglected topic of research, particularly in the "eld of heating, ventilating and air-conditioning ducts. Since then, interest has grown and many publications have appeared in which predictive methods h
SOUND TRANSMISSION THROUGH ELASTOMERIC BULB SEALS
โ Scribed by J. PARK; T. SIEGMUND; L. MONGEAU
- Publisher
- Elsevier Science
- Year
- 2003
- Tongue
- English
- Weight
- 671 KB
- Volume
- 259
- Category
- Article
- ISSN
- 0022-460X
No coin nor oath required. For personal study only.
โฆ Synopsis
The sound barrier performance of elastomeric vehicle weather seals was investigated. Experiments were performed on a single bulb seal specimen using a reverberation room method. The seal wall velocity was measured using a laser Doppler vibrometer. The sound pressure near the velocity measurement location was measured simultaneously, which allowed the sound intensity on both sides of the seal and the sound transmission loss to be determined. The vibration response and the sound transmission loss of the bulb seal were then computed using finite element analysis. Acoustic-structure interactions were considered for a partially coherent spatially distributed pressure excitation. The experimental data obtained using the reverberation room method allowed the validation of the numerical models. The resonance frequency due to the mass-air-mass mode of vibration was accurately predicted. The model was then used to numerically investigate the influence of various design parameters. It was found that the elastic modulus significantly affects the bulb seal resonance frequency, and that the loss factor of the material has major effects on the sound transmission loss around resonance.
๐ SIMILAR VOLUMES
Sound transmission through a double wall with a masonry leaf and a lightweight leaf is examined by using statistical energy analysis (SEA). Some of the theory necessary to predict transmission is well documented and common to other forms of construction. Additional expressions are provided to accoun
A theoretical model of sound transmission across metal ties in a cavity wall is presented in which power flows across independent point contacts between the two leaves of the wall. From a knowledge of the mobilities of the walls and the tie stiffness, the power flow across the ties can be determined
Active suppression of the acoustic transmission through plate structure is the major target of this paper. The model consists of a plane acoustic wave incident onto a clamped elastic rectangular thin plate and the piezoceramic patches modelled as four point moments are bonded on the surface of the p