Sorption kinetics of ethanol/water solution by dimethacrylate-based dental resins and resin composites
✍ Scribed by Irini D. Sideridou; Dimitris S. Achilias; Maria M. Karabela
- Publisher
- John Wiley and Sons
- Year
- 2007
- Tongue
- English
- Weight
- 741 KB
- Volume
- 81B
- Category
- Article
- ISSN
- 1552-4973
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
In the present investigation the sorption–desorption kinetics of 75 vol % ethanol/water solution by dimethacrylate‐based dental resins and resin composites was studied in detail. The resins examined were made by light‐curing of bisphenol A glycol dimethacrylate (Bis‐GMA), triethylene glycol dimethacrylate (TEGDMA), urethane dimethacrylate (UDMA), bisphenol A ethoxylated dimethacrylate (Bis‐EMA), and mixtures of these monomers. The resin composites were prepared from two commercial light‐cured restorative materials (Z100 MP and Filtek Z250), the resin matrix of which is based on copolymers of the above‐mentioned monomers. Ethanol/water sorption/desorption was examined in both equilibrium and dynamic conditions in two adjacent sorption–desorption cycles. For all the materials studied, it was found that the amount of ethanol/water sorbed or desorbed was always larger than the corresponding one reported in literature in case of water immersion. It was also observed that the chemical structure of the monomers used for the preparation of the resins directly affects the amount of solvent sorbed or desorbed, as well as sorption kinetics, while desorption rate was nearly unaffected. In the case of composites studied, it seems that the sorption/desorption process is not influenced much by the presence of filler. Furthermore, diffusion coefficients calculated for the resins were larger than those of the composites and were always higher during desorption than during sorption. Finally, an interesting finding concerning the rate of ethanol/water sorption was that all resins and composites followed Fickian diffusion kinetics during almost the whole sorption curve; however, during desorption the experimental data were overestimated by the theoretical model. Instead, it was found that a dual diffusion–relaxation model was able to accurately predict experimental data during the whole desorption curve. Kinetic relaxation parameters, together with diffusion coefficients, are reported for all resins and composites. © 2006 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 2006
📜 SIMILAR VOLUMES
## Abstract A near infrared (NIR) method using the 5200 cm^−1^ absorption of water has been employed to examine water absorbed in photopolymerized dental resins and composites in the form of 0.01‐cm‐to 0.15‐cm‐thick specimens. The concentration, __c__ [mol L^−1^], of absorbed water in specimens of