✦ LIBER ✦

Some aspects of the fatigue behaviour of fibre reinforced thermosetting resins

✍ Scribed by R.M. Mayer; A. Pearce; P.J. Worthington

Publisher: Elsevier Science
Year: 1984
Tongue: English
Weight: 359 KB
Volume: 2
Category: Article
ISSN: 0263-8223
DOI: 10.1016/0263-8223(84)90002-3

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Intralaminar fatigue behaviour of carbon

Intralaminar fatigue behaviour of carbon fibre reinforced plastics

✍ V. Trappe; K.-W. Harbich 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 824 KB

A new approach is discussed for characterizing the damage state of FRP with the appearance of micro cracking and its influence on the residual strength. For the quantitative analysis of micro cracking, X-ray refraction topography was used. Fatigue treatment of carbon fibre reinforced plastics (CFRP)

Impact Fatigue Behaviour of Rubber-Modif

Impact Fatigue Behaviour of Rubber-Modified Glass Fibre Reinforced Polyamide 6

✍ Dirk J. Dijkstra; Volker Altstaedt; Niladri Mitra 📂 Article 📅 2001 🏛 John Wiley and Sons 🌐 English ⚖ 190 KB

Modelling of flexural fatigue behaviour

Modelling of flexural fatigue behaviour in UD glass-fibre-reinforced polymer

✍ M. Salvia; L. Vincent 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 733 KB

The fracture behaviour of fibre reinforc

The fracture behaviour of fibre reinforced concrete

✍ B. Harris; J. Varlow; C.D. Ellis 📂 Article 📅 1972 🏛 Elsevier Science 🌐 English ⚖ 730 KB

The work of fracture, YF, and the critical stress intensity factor Kc, have been determined for the failure in bending of notched samples of sand/cement mortar reinforced with short, randomlydistributed fibres of glass, high carbon steel, and mild steel. Results were obtained on wet and dry stored m

Creep and creep-fatigue behaviour of con

Creep and creep-fatigue behaviour of continuous fibre reinforced glass-ceramic matrix Composites

✍ B. Eng. G. West; Dr.-Ing. A. R. Boccaccini; Prof. Dr. D. M. R. Taplin 📂 Article 📅 1995 🏛 John Wiley and Sons 🌐 English ⚖ 688 KB

## Abstract The flexural creep and creep strain recovery behaviour during creep‐fatigue tests of a cross‐ply SiC fibre reinforced Barium Magnesium Aluminosilicate glass‐ceramic matrix composite was investigated at 1100°C in air. Only heat‐treated samples (1 h at 1100°C) were tested. Stress levels o

Fatigue delamination behaviour of unidir

Fatigue delamination behaviour of unidirectional carbon fibre/epoxy laminates reinforced by Z-Fiber® pinning

✍ Denis D.R. Cartié; Jean-Martin Laffaille; Ivana K. Partridge; Andreas J. Brunner 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 764 KB

Z-Pin reinforced carbon-fibre epoxy laminates were tested under Mode I and Mode II conditions, both quasi-statically and in fatigue. Test procedures were adapted from existing standard or pre-standard tests. Samples containing 2% and 4% areal densities of carbonfibre Z-pins (0.28 mm diameter) were c