𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Size Limitations in Semicircular Duct Systems

✍ Scribed by M. Muller


Book ID
102975853
Publisher
Elsevier Science
Year
1999
Tongue
English
Weight
709 KB
Volume
198
Category
Article
ISSN
0022-5193

No coin nor oath required. For personal study only.

✦ Synopsis


The present article discusses mechanical requirements and limitations which are applicable to the construction of the system of semicircular ducts, especially to its size. The simplified case of a single, uniform duct system has been considered which can be described by a second order equation of motion. The principal functional quantities for this rotation-sensor are: (1) response speed; (2) sensitivity; and (3) regular flow. The response speed of a single, uniform semicircular duct is characterized by the short time constant (T2) which is dependent on the duct radius (r). Its estimated range is from 0.04 ms in the smallest to 140 ms in the largest known labyrinth. The sensitivity is characterized by the maximal endolymph displacement after a step stimulus (xmax). Its estimated range is from 0.0016 &mgrm to 5.97 mm (6.56 decades!), assuming an input angular velocity of omega=1 rad s-1. The Reynolds number is a measure for an undisturbed laminar flow. Its estimated range varies from 7.38.10(-4)to 45.1 for omega=1 rad s-1. The above data follow from graphs in which, for a single uniform duct, circuit radius (R) is plotted against duct radius (r) for labyrinths of 233 species belonging to different vertebrate-groups. A relation R =38.9. r1.60was determined. The smallest labyrinth was found in a carp larva (Cyprinus), the largest in a whale shark (Rhincodon). Large whales possess labyrinths of average mammalian size. It is revealed that semicircular duct size is bound by requirements concerning regular flow and by a too low response speed for large labyrinths, and by a too low sensitivity for small labyrinths. Other important quantities are mechanical amplification factors which are a consequence of more complex vestibular constructions than a single uniform duct circuit. Allometric relationships are interpreted as compromises between the quantities mentioned. A hypothesis for the relatively large semicircular duct sizes of fishes, especially Elasmobranchii, compared with mammals and birds is presented. Copyright 1999 Academic Press.


πŸ“œ SIMILAR VOLUMES


Optimization of the Mechanical Performan
✍ M. MULLER; J.H.G. VERHAGEN πŸ“‚ Article πŸ“… 2002 πŸ› Elsevier Science 🌐 English βš– 416 KB

The classical representation of the semicircular duct system consists of three separate duct circuits. The ducts are, however, in reality, hydrodynamically interconnected. Muller & Verhagen (1988a,b) derived equations for the mechanical behaviour of an interconnected system with three ducts (anterio

Optimization of the Mechanical Performan
✍ M. MULLER; J.H.G. VERHAGEN πŸ“‚ Article πŸ“… 2002 πŸ› Elsevier Science 🌐 English βš– 591 KB

In the majority of vertebrates, the horizontal duct of the vestibular system lies approximately in the yawing plane of the head. The positioning of the vertical ducts, however, is not in the pitch- and roll planes but the vertical ducts generally lie under an angle of about 30-45 degrees relative to

Optimization of the Mechanical Performan
✍ M. MULLER; J.H.G. VERHAGEN πŸ“‚ Article πŸ“… 2002 πŸ› Elsevier Science 🌐 English βš– 507 KB

The endolymph flow inside the semicircular ducts is analytically investigated by considering a system of two hydrodynamically interconnected ducts. Rotation of this system adds an amount of motion (momentum) to parts of it. This results in an endolymph flow in generally all vestibular parts. The "ex

Limitations in tracking systems
✍ Ivan Lopez Hurtado; Chaouki T. Abdallah; Sudharman K. Jayaweera πŸ“‚ Article πŸ“… 2010 πŸ› South China University of Technology and Academy o 🌐 English βš– 292 KB