✦ LIBER ✦

Single Pulse Temperature Measurements in Flames by Thermally Assisted Atomic Fluorescence Spectroscopy

✍ Scribed by Elder, Melanie L.; Zizak, G.; Bolton, D.; Horvath, J. J.; Winefordner, J. D.

Book ID: 115359815
Publisher: Society for Applied Spectroscopy
Year: 1984
Tongue: English
Weight: 591 KB
Volume: 38
Category: Article
ISSN: 0003-7028
DOI: 10.1366/0003702844554134

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Temperature measurements in flames using

Temperature measurements in flames using thermally assisted laser-induced fluorescence of Ga

✍ Joklik, Richard G. ;Horvath, J. J. ;Semerjian, H. G. 📂 Article 📅 1991 🏛 The Optical Society 🌐 English ⚖ 909 KB

Application of the thermally assisted at

Application of the thermally assisted atomic fluorescence technique to the temperature measurement in a gasolineair flame

✍ G. Zizak; J.D. Winefordner 📂 Article 📅 1982 🏛 Elsevier Science 🌐 English ⚖ 306 KB

Laser-induced thermally assisted atomic fluorescence is used to determine the temperature in a gasoline-air flame. The theoretical basis is presented and the advantages and disadvantages of this technique are discussed. The experimental apparatus and the results for a flame produced by a small labor

Direct measurement of OH local concentra

Direct measurement of OH local concentration in a flame from the fluorescence induced by a single laser pulse

✍ Stepowski, D. ;Cottereau, M. J. 📂 Article 📅 1979 🏛 The Optical Society 🌐 English ⚖ 340 KB

Oxygen interaction of CdS-based gas sens

Oxygen interaction of CdS-based gas sensors with different stoichiometric compositions was studied by X-ray photoelectron spectroscopy (XPS) and thermal-desorption mass spectroscopy observations combined with conductivity measurements. Three different types of film with different atomic ratios of Cd/S were used in the study of oxygen chemisorption in a low-temperature range between 300 and 570 K. Spray pyrolysis was used for the deposition of the films on glass substrates; XPS and energy dispersive spectroscopy of X-ray together with atomic force microscopy and scanning electron microscopy were used for the characterization of the composition and structure of the films. It was possible to distinguish different temperature ranges for the thermal desorption of the different adsorbed oxygen species. A comparison of the data from XPS and mass-spectroscopy observations with conductance measurements allows to conclude that metallic surface atoms are responsible for different interactions of oxygen species with CdS surfaces.

📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 379 KB