✦ LIBER ✦

Simulation of machining 3D free-form surface in normal direction using 6-SSP and 4SPS+UPU parallel machine tools

✍ Scribed by Yi Lu

Publisher: Springer
Year: 2006
Tongue: English
Weight: 542 KB
Volume: 33
Category: Article
ISSN: 0268-3768
DOI: 10.1007/s00170-006-0547-x

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Simulation of pre-solving active forces

Simulation of pre-solving active forces of a 4SPS+SPR parallel machine tool in normal machining a 3D free-form surface

✍ Yi Lu; Jiayin Xu; Jianping Yu 📂 Article 📅 2009 🏛 Springer 🌐 English ⚖ 446 KB

Simulation of normal machining of 3D fre

Simulation of normal machining of 3D free-form surface by an orthogonal 3-leg parallel machine tool with 5-DOF

✍ Yi Lu; Shuyan Li; Chongjie Du; Jianping Yu; Jiayin Xu 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 759 KB

A novel orthogonal 3-leg parallel machine tool (PMT) with 5 DOFs is designed for normal machining a 3D free-form surface s. A CAD variation geometry approach is adopted for pre-solving the extension/rotation of the linear/rotational actuators and the pose of this PMT. First, a simulation mechanism o

Simulation solving/modifying velocity an

Simulation solving/modifying velocity and acceleration of a 4UPS+SPR type parallel machine tool during normal machining of a 3D free-form surface

✍ Yi Lu; Jiayin Xu 📂 Article 📅 2008 🏛 Springer 🌐 English ⚖ 640 KB