SCADAPack 570 Hardware Manual
Legal Information
Technical Support
Safety Information
About the Book
About the SCADAPack 570
Cybersecurity
Hardware Overview
Processing and Storage
Power Supply and Back-Up Battery
Serial Ports
Serial1 and Serial2 Ports
Serial3 and Serial4 Ports
Ethernet Ports
Eth1, 2, 3 Ports
USB Ports
USB Host Port
USB Device Port
Formatting a USB Drive
Inputs and Outputs
Digital Inputs
Counter Inputs
Digital Outputs
Ground Connectors
Isolation and Protection Summary
Installation
ATEX Requirements
Mounting the SCADAPack 570
Power Supply Requirements
Power Supply Wiring
Adding Inputs and Outputs
Precautions
I/O Module Power Supply Requirements
Cabling Guidance
Attaching Intermodule Cables
Removing a Ribbon Cable
Mode Selection
Field Wiring
Wiring Screw-Termination Connectors
Serial Port Wiring
RS232 Pin Assignments
RS232 Cable Descriptions
RS232 Wiring Examples
RS485 Wiring
Ethernet Port Wiring
Ethernet Pin Assignments
Ethernet Cable Descriptions
Digital Input Wiring
Digital Input Wiring Example
Digital Output Wiring
Digital Output Wiring Example
Controlling Devices with the Controller Board Digital Output
Startup Modes
Run Mode
Service Boot Mode
Cold Boot Mode
Factory Boot Mode
Configuration
Diagnostics
LEDs
Accessing Diagnostics
Startup Diagnostics
Internal Temperature Reading
Power Supply and Battery Status
Communication Statistics
Status Information
Maintenance
Calibration
Preventive Maintenance
Routine Maintenance
Replacing the Battery
Updating Firmware
Updating the Bootloader
Specifications
General
Power Supply
Controller Board
Data Capacity
Communications
Digital Inputs
Counter Inputs
Digital Outputs
Standards and Certifications