✦ LIBER ✦

Rheological testing methods for gypsum plaster pastes

✍ Scribed by B. Caufin; A. Papo

Book ID: 112757045
Publisher: Springer
Year: 1983
Tongue: English
Weight: 456 KB
Volume: 16
Category: Article
ISSN: 1871-6873
DOI: 10.1007/bf02473812

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Rheological models for gypsum plaster pa

Rheological models for gypsum plaster pastes

✍ A. Papo 📂 Article 📅 1988 🏛 Springer-Verlag 🌐 English ⚖ 439 KB

Rheological behavior of gypsum plaster p

Rheological behavior of gypsum plaster pastes

✍ Caufin, Biagio; Lapasin, Romano; Papo, Adriano 📂 Article 📅 1985 🏛 American Chemical Society ⚖ 509 KB

A New Method for Abrasivity Test for Too

A New Method for Abrasivity Test for Tooth Pastes

✍ Güven, K. C. ;Araman, A. 📂 Article 📅 1985 🏛 John Wiley and Sons ⚖ 417 KB

a n d A . A r a m a n \* Ein news Verfahren zur Bestimmung der Abrasitjit von Zahnpasten Es wird ein neues Verfahren zur Bestimmung der Abrasitat von Zahnpasten beschrieben. Dies Verfahren beruht auf dor Bestimmung der Abnahme der Adsorption des Farbstoffes auf dem Zahnschmelz. Die Abnahme wurde der

Standardization of a shear test method f

Standardization of a shear test method for lead-free solder paste chip joints

✍ Jai-Kyoung Choi; Jai-Hyun Park; Yong-Sik Ahn 📂 Article 📅 2007 🏛 Springer 🌐 English ⚖ 407 KB

TRIAL METHOD FOR MEASURING THE EFFECT OF

TRIAL METHOD FOR MEASURING THE EFFECT OF LIPIDS ON THE RHEOLOGICAL PROPERTIES OF STARCH PASTE DURING THE GELATION PROCESS

✍ RITSUKO NIIHARA; SACHIO MATSUMOTO 📂 Article 📅 1981 🏛 John Wiley and Sons 🌐 English ⚖ 537 KB

Development of a test method for the rhe

Development of a test method for the rheological characterization of polymers under the injection molding process conditions

✍ P.F. Bariani; M. Salvador; G. Lucchetta 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 242 KB

The reliability of numerical simulations of the injection molding process depends mainly on the rheological characteristics of polymers. The rheological characterization of a polymer for injection molding is commonly carried out by a capillary rheometer. However, in this method the measurement is ca