A neural network based approach for product design is addressed in this article. Computer modeling, fuzzy set theory and semantic difference method are applied to set up an experiment. The experimental results are analyzed by applied back-propagation neural network, which establish the relationships
Reuse of CAD designs by a neural-network approach
β Scribed by Andreas Scherer
- Publisher
- Elsevier Science
- Year
- 1996
- Tongue
- English
- Weight
- 717 KB
- Volume
- 9
- Category
- Article
- ISSN
- 0952-1976
No coin nor oath required. For personal study only.
π SIMILAR VOLUMES
## Abstract An original comodeling approach based on neural network is proposed in order to optimize multichip modules (MCM). This approach permits to characterize and to optimize millimeterβwave module behavior by taking into account electromagnetic phenomena. All the design procedure is implement
Figure 6 Measured axial ratio in the broadside direction against frequency for the proposed antenna in Figure 5 with left-hand CP Ε½ . radiation feed at point A ; h s 1.6 mm, s 4.4, L s 30 mm, r Ε½ . Ε½ . Ε½ . S s 6.4 mm 4.7 β , 5.0 mm 0 β , d s 11.2 mm 4.7 β , 12.2 mm Ε½ . 0 β TABLE 2 Characteristics of
## Abstract With the introduction of the Power Exchange, one of the most critical issues to be faced by a Transmission System Operator (TSO) is to take into account the transmission constraints in a simplified market model. The zonal approach represents a suitable solution, since its mechanism can