✦ LIBER ✦

Residual stresses in and around rivets in clad aluminum alloy plates

✍ Scribed by T.J. Fitzgerald; J.B. Cohen

Publisher: Elsevier Science
Year: 1994
Tongue: English
Weight: 617 KB
Volume: 188
Category: Article
ISSN: 0921-5093
DOI: 10.1016/0921-5093(94)90355-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A simplified numerical analysis of resid

A simplified numerical analysis of residual stresses in aluminum welded plates

✍ J. Cañas; R. Picón; F. Pariís; A. Blazquez; J.C. Marín 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 947 KB

An FE analysis for assessing the effect

An FE analysis for assessing the effect of short-term exposure to elevated temperature on residual stresses around cold expanded fastener holes in aluminum alloy 7075-T6

✍ A.B. Aghdam; T.N. Chakherlou; K. Saeedi 📂 Article 📅 2010 🏛 Elsevier Science ⚖ 1000 KB

Experimental study of nonlinear Rayleigh

Experimental study of nonlinear Rayleigh wave propagation in shot-peened aluminum plates—Feasibility of measuring residual stress

✍ Minghe Liu; Jin-Yeon Kim; Laurence Jacobs; Jianmin Qu 📂 Article 📅 2011 🏛 Elsevier Science 🌐 English ⚖ 405 KB

Shot-peening is widely used in the aerospace industry to enhance the resistance of structural components to fatigue damage and stress corrosion by putting the outside layer of a component under an initial, residual compressive stress. The ability to measure these near-surface residual stresses is us

Neutron and synchrotron radiation diffra

Neutron and synchrotron radiation diffraction study of the matrix residual stress evolution with plastic deformation in aluminum alloys and composites

✍ Pedro Fernández-Castrillo; Giovanni Bruno; Gaspar González-Doncel 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 694 KB

Modeling thermal and stress behavior of

Modeling thermal and stress behavior of the fuel–clad interface in monolithic fuel mini-plates

✍ Gregory K. Miller; Douglas E. Burkes; Daniel M. Wachs 📂 Article 📅 2010 🏛 Elsevier Science ⚖ 838 KB

The residual stress-induced buckling of

The residual stress-induced buckling of annular thin plates and its application in residual stress measurement of thin films

✍ Da-Yong Qiao; Wei-Zheng Yuan; Yi-Ting Yu; Qing Liang; Zhi-Bo Ma; Xiao-Ying Li 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 878 KB

The buckling method is presently one of the most commonly used methods in residual stress measurement, but still suffers from the problem that an array of structures occupying a large die area is required. In this paper, the buckling characteristics of annular thin plates were investigated and a new