✦ LIBER ✦

Research on microstructure and mechanical properties of a new α + Ti2Cu alloy after semi-solid deformation

✍ Scribed by Y.Q. Zhao; W.L. Wu; H. Chang

Publisher: Elsevier Science
Year: 2006
Tongue: English
Weight: 984 KB
Volume: 416
Category: Article
ISSN: 0921-5093
DOI: 10.1016/j.msea.2005.10.038

No coin nor oath required. For personal study only.

✦ Synopsis

The microstructures and tensile mechanical properties of Ti14, a new typical ␣ + Ti 2 Cu alloy, after semi-solid forging were researched. The results reveal that its microstructure is coarse and the grain boundary is wide after semi-solid forging, leading to low plasticity at room temperature. Recrystallization heat treatment leads to fine microstructure, which is similar to that of conventional forging, resulting in improvement of tensile mechanical properties. The mechanical properties of semi-solid forging are similar to that of conventional one at high temperature.

📜 SIMILAR VOLUMES

Microstructures and mechanical propertie

Microstructures and mechanical properties of Ti–45 at.%Ni–5 at.%Cu alloy ribbons containing Ti2Ni particles

✍ Tae-Hyun Nam; Jae-Hwa Lee; Jung-Min Nam; Ki-Won Kim; Gyu-Bong Cho; Yeon-Wook Kim 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 377 KB

Research on microstructure and mechanical properties of a new α&#xa0;+&#xa0;Ti2Cu alloy after semi-solid deformation

✦ Synopsis

Research on microstructure and mechanical properties of a new α + Ti2Cu alloy after semi-solid deformation