Quantifying desorption and rearrangement rates of carbon monoxide on a PEM fuel cell electrode
โ Scribed by Vijay A. Sethuraman; Balasubramanian Lakshmanan; John W. Weidner
- Publisher
- Elsevier Science
- Year
- 2009
- Tongue
- English
- Weight
- 945 KB
- Volume
- 54
- Category
- Article
- ISSN
- 0013-4686
No coin nor oath required. For personal study only.
โฆ Synopsis
A simple procedure to quantify the rates of carbon monoxide (CO) desorption from, and simultaneous rearrangement on, supported platinum fuel cell electrode (Pt on Vulcan XC-72R) is reported. The surface coverage of CO on Pt electrode in equilibrium with bulk CO was measured from the anodic peaks in the CO stripping voltammogram. The decline in these surface coverages due to desorption and rearrangement, once CO was replaced by N 2 in the gas phase was recorded and used in conjunction with a kinetic model to quantify the respective rates. Two distinct CO oxidation peaks observed in the voltammogram due to the oxidation of two distinct ad-species, namely weakly and strongly adsorbed CO (CO I ad and CO II ad ), were baseline corrected and deconvoluted using a bimodal Gaussian distribution. Saturation surface coverage of CO I ad decreased with increasing temperature, while the opposite was true for CO II ad . Rearrangement from CO II ad to CO I ad was faster than the desorption rate of either CO species. The desorption rate of CO II ad was at least an order of magnitude lower than that of CO I ad molecules at all temperatures studied. The activation energies for desorption of CO I ad and CO II ad were estimated to be 24.08 and 27.99 kJ/mol, respectively. The activation energy for rearrangement from CO I ad to CO II ad was 35.23 kJ/mol and that from CO II ad to CO I ad was 27.55 kJ/mol.
๐ SIMILAR VOLUMES
The electrocatalytic activity for CO, H 2 /CO and CH 3 OH oxidation of Pt-Sn catalysts has been extensively investigated for a possible use as anode materials for low-temperature fuel cells. This paper presents an overview of the relationship between the structural characteristics of the catalysts (
Derived from petroleum or coal heavy oils, carbonaceous materials or resin powders are impregnated with metal compounds such as nitrates, chlorides and hydroxides and then carbonized and graphitized to give partially graphitized crystalline carbonaceous materials as the battery anodes. The anodes an