𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Properties of cupola slag as a pozzolana and its effects on partial replacement of cement in a mortar

✍ Scribed by D.A. Aderibigbe; A.E. Ojobo


Publisher
Elsevier Science
Year
1982
Weight
416 KB
Volume
5
Category
Article
ISSN
0361-3658

No coin nor oath required. For personal study only.


πŸ“œ SIMILAR VOLUMES


Effect of copper slag as a fine aggregat
✍ Khalifa S. Al-Jabri; Abdullah H. Al-Saidy; Ramzi Taha πŸ“‚ Article πŸ“… 2011 πŸ› Elsevier Science 🌐 English βš– 992 KB

An experimental investigation was conducted to study the effect of using copper slag as a fine aggregate on the properties of cement mortars and concrete. Various mortar and concrete mixtures were prepared with different proportions of copper slag ranging from 0% (for the control mixture) to 100% as

Coarse blast furnace slag as a cementiti
✍ J.I. Escalante-Garcia; L.J. Espinoza-Perez; A. Gorokhovsky; L.Y. Gomez-Zamorano πŸ“‚ Article πŸ“… 2009 πŸ› Elsevier Science 🌐 English βš– 400 KB

The cementitious performance of a coarse granulated blast furnace slag, 2900 cm 2 /g, was investigated in concretes of 230, 280 and 330 kg binder/m 3 . First, the slag partially replaced 30%, 50% and 70% of Portland cement, the strength reduced as the amount of slag increased; however, for high bind

Effects of cement creep on stem subsiden
✍ Lu, Z. ;McKellop, H. πŸ“‚ Article πŸ“… 1997 πŸ› John Wiley and Sons 🌐 English βš– 353 KB πŸ‘ 1 views

In cemented total hip prostheses, the role of creep of the occurred with all three bonding conditions, allowing addiacrylic cement (polymethyl methacrylate, [PMMA]) in in-tional subsidence of the stem and a decrease in the stress creasing or decreasing the chance of failure of the cement components

A new approach in evaluation of filler e
✍ P. KrstuloviΔ‡; N. KameniΔ‡; K. PopoviΔ‡ πŸ“‚ Article πŸ“… 1994 πŸ› Elsevier Science 🌐 English βš– 362 KB

The mortar and concrete specimens of equal bulk model were tested. Under this condition, their properties depend on the composition of cementitious powder only. The influence of all other components and parameters is thus excluded. The test results of the compressive strength were evaluated statist