✦ LIBER ✦

Production of benzene and toluene in commercial catalytic reforming units

✍ Scribed by G. M. Avdei; R. N. Shapiro; G. N. Maslyanskii; V. V. Shipikin; Z. M. Kurkovskii

Publisher: Springer US
Year: 1975
Tongue: English
Weight: 355 KB
Volume: 11
Category: Article
ISSN: 0009-3092
DOI: 10.1007/bf00717377

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Improving regenerative technology of cat

Improving regenerative technology of catalytic reforming in commercial units

✍ Yu. A. Skipin; E. L. Lobanov; G. G. Kovrov; V. B. Maryshev; M. Yu. Lysukhin 📂 Article 📅 1989 🏛 Springer US 🌐 English ⚖ 288 KB

Corrosion protection of equipment and li

Corrosion protection of equipment and lines in catalytic reforming units

✍ G. A. Andreeva; V. V. Burlov; O. N. Prasolva 📂 Article 📅 1985 🏛 Springer US 🌐 English ⚖ 298 KB

Protonated combustion products of benzen

Protonated combustion products of benzene, toluene and cyclohexane in the flame ionization detector

✍ T. McAllister; J.D. Scott 📂 Article 📅 1980 🏛 Elsevier Science ⚖ 600 KB

Intensification of hydrogen production v

Intensification of hydrogen production via methane reforming and the optimization of H2:CO ratio in a catalytic reactor with a hydrogen-permeable membrane wall

✍ S.I. Prokopiev; Yu.I. Aristov; V.N. Parmon; N. Giordano 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 325 KB

Methanol steam reforming in supported Pd

Methanol steam reforming in supported Pd membrane reactor The supported Pd membrane is promising for the production of high-purity hydrogen from catalytic steam reforming of methanol. At the 35°C reaction temperature, the catalyst activity and stability are promoted by increasing the alumina content. Here a compact doublejacketed reactor has generated high-purity hydrogen directly from steam reforming of methanol, with no need for external purification and a much higher recovery yield.

📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 110 KB

environments was investigated. The corrosion rate is higher under 'outlet' conditions at 700°C compared to standard conditions at 650°C and 'inlet' conditions at 600°C. The corrosion potential increases with time when a protective corrosion layer is formed. Eventually it reaches a more positive pote