✦ LIBER ✦

Pressure distribution in a stratum during the start-up of a well with a self-establishing flow

✍ Scribed by A. M. Il'yasov; V. A. Isyakaev; G. D. Likhovol; M. M. Nagumanov

Publisher: Springer
Year: 1972
Tongue: English
Weight: 202 KB
Volume: 7
Category: Article
ISSN: 0015-4628
DOI: 10.1007/bf01205770

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Pressure distribution in narrow slotted

Pressure distribution in narrow slotted channels during flow of a rarefied gas with slippage and a phase transition at the walls

✍ B. M. Smol'skii; L. Ya. Lyubin; P. A. Novikov; G. L. Malenko; V. I. Svershcheck 📂 Article 📅 1973 🏛 Springer US 🌐 English ⚖ 384 KB

Non-uniform flow distribution in the ste

Non-uniform flow distribution in the steam generator U-tubes of a pressurized water reactor plant during single- and two-phase natural circulations

✍ Jae-Jun Jeong; Moonkyu Hwang; Young Jin Lee; Bub Dong Chung 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 298 KB

A flow model is formulated to analyze the single-and two-phase flow characteristics in the primary side of a vertical, inverted U-tube steam generator. Using the flow model, a pressure drop-mass flow rate curve is derived. It is shown that the curve has a negative slope and, thus, flow excursion ins

Study of the critical heat flux conditio

Study of the critical heat flux condition with water and R-123 during flow boiling in microtubes. Part II – Comparison of data with correlations and establishment of a new subcooled CHF correlation

✍ A.P. Roday; M.K. Jensen 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 463 KB

This study's objective was to better understand the CHF condition in microchannels. The effect of different operating parameters -mass flux, inlet subcooling, exit quality, heated length and diameter -were assessed in detail in Part I of the study and compared to the behavior in conventional sized c