✦ LIBER ✦

Preparation of ultra-high strength polyethylene fibres by gel-spinning/hot-drawing at high spinning rates

✍ Scribed by J. Smook; A. J. Pennings

Publisher: Springer
Year: 1983
Tongue: English
Weight: 717 KB
Volume: 9
Category: Article
ISSN: 0170-0839
DOI: 10.1007/bf00275571

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Ultra-high strength polyethylene filamen

Ultra-high strength polyethylene filaments by solution spinning/drawing. 3. Influence of drawing temperature

✍ Paul Smith; Piet J. Lemstra 📂 Article 📅 1980 🏛 Elsevier Science 🌐 English ⚖ 263 KB

High-strength poly(L-lactide) fibers by

High-strength poly(L-lactide) fibers by a dry-spinning/hot-drawing process. I. Influence of the ambient temperature on the dry-spinning process

✍ A. R. Postema; A. H. Luiten; A. J. Pennings 📂 Article 📅 1990 🏛 John Wiley and Sons 🌐 English ⚖ 785 KB

In this paper the influence of the ambient temperature of the spinline during dry spinning of PLLA solutions has been discussed. Variation of this ambient temperature induced variation of the extrudate swell of the spinline, affected by the rate of solidification of the PLLA. By way of phase separat

High-strength poly(L-lactide) fibers by

High-strength poly(L-lactide) fibers by a dry-spinning/hot-drawing process. II. Influence of the extrusion speed and winding speed on the dry-spinning process

✍ A. R. Postema; A. H. Luiten; H. Oostra; A. J. Pennings 📂 Article 📅 1990 🏛 John Wiley and Sons 🌐 English ⚖ 921 KB

This paper is concerned with the influences of the extrusion speed and the winding speed during dry spinning of 4 w t '% solutions of poly(L-lactide) (PLLA) in mixtures of chloroform and toluene, on the ultimate fiber tenacities after hot drawing. It was found that high-strength PLLA fibers (1.5 GPa