𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Prediction of the optinum dimensions of the crystalline grains for the deep-drawing of metals

✍ Scribed by Li Miaoquan

Publisher
Elsevier Science
Year
1991
Tongue
English
Weight
230 KB
Volume
26
Category
Article
ISSN
0924-0136

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

On the prediction of delamination during
On the prediction of delamination during deep-drawing of polymer coated metal sheet
✍ M.J. van den Bosch; P.J.G. Schreurs; M.G.D. Geers πŸ“‚ Article πŸ“… 2009 πŸ› Elsevier Science 🌐 English βš– 655 KB

This paper describes the development and application of a numerical model that can predict the delamination of the polymer coating from the steel substrate during deep-drawing. Experimentally characterized cohesive zones are used to describe the interface between the polymer and the steel and are c

Prediction of Parameters for the Burr Di
Prediction of Parameters for the Burr Dimensions in Short-Hole Drilling
✍ U. Heisel; M. Luik; R. Eisseler; M. Schaal πŸ“‚ Article πŸ“… 2005 πŸ› International Academy for Production Engineering 🌐 English βš– 686 KB

The following paper presents a method for the determination of the burr dimensions to be expected in shorthole drilling, simultaneously taking the parameters into consideration which influence the burr formation. These parameters are yield stress, forces and the geometry of the inserts. The method i

A new analytical solution for prediction
A new analytical solution for prediction of forward tension in the drawing process
✍ HernΓ‘n A. GonzΓ‘lez Rojas; Joan Vivancos Calvet; V.I. Bubnovich πŸ“‚ Article πŸ“… 2008 πŸ› Elsevier Science 🌐 English βš– 464 KB

Tension in the drawing process is determined via a new solution to the drawing problem for dies of axisymmetric or symmetric sections. A free body equilibrium method is used to obtain the equations that dictate the drawing phenomenon. As opposed to the classical slab method, solution of these equati