✦ LIBER ✦

Prediction of the forming limit curves of sheet materials using the rigid-plastic finite element method

✍ Scribed by C.H. Toh

Publisher: Elsevier Science
Year: 1989
Tongue: English
Weight: 509 KB
Volume: 29
Category: Article
ISSN: 0890-6955
DOI: 10.1016/0890-6955(89)90004-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Rigid—plastic finite-element analysis of

Rigid—plastic finite-element analysis of sheet-metal forming processes using a selective membrane/shell formulation

✍ I.S. Song; H.B. Shim; D.Y. Yang 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 798 KB

A FINITE ELEMENT FORMULATION OF THE RIGI

A FINITE ELEMENT FORMULATION OF THE RIGID–PLASTIC LIMIT ANALYSIS PROBLEM

✍ ANTONIO CAPSONI; LEONE CORRADI 📂 Article 📅 1997 🏛 John Wiley and Sons 🌐 English ⚖ 521 KB

A procedure for the finite element computation of the limit load of rigid-perfectly plastic solids is presented. The approach is based on the kinematic theorem of limit analysis, which is formulated so as to reduce the problem to the search of the essentially free minimum of a convex, but not everyw

Analysis of the forming process of sinte

Analysis of the forming process of sintered powder metals by a rigid-plastic finite-element method

✍ K. Mori; K. Osakada 📂 Article 📅 1987 🏛 Elsevier Science 🌐 English ⚖ 492 KB

Forming-limit analysis of hemispherical-

Forming-limit analysis of hemispherical-punch stretching using the three-dimensional finite-element method

✍ T. Yoshida; T. Katayama; M. Usuda 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 494 KB

The deformation analysis of hemispherical-punch stretching was performed using the threedimensional finite-element program "ROBUST". The effects of the material properties on strain distribution and histories of the deformation processes were investigated. Using FE-calculation results and forming-li

Simulation of plane-strain rolling by th

Simulation of plane-strain rolling by the rigid-plastic finite element method

✍ K. Mori; K. Osakada; T. Oda 📂 Article 📅 1982 🏛 Elsevier Science 🌐 English ⚖ 498 KB

Computer simulation of U-channel for und

Computer simulation of U-channel for under-rail roll forming using rigid-plastic finite element methods

✍ S.H. Jeong; S.H. Lee; G.H. Kim; H.J. Seo; T.H. Kim 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 399 KB

Cold-roll forming (CRF) is a well-known process used to manufacture long sheet metal products with constant cross-section. This process makes it possible to manufacture intricate sheet metal products which cannot be made through the press process. It is a very important process in many industrial fi