Prediction of fiber orientation in injection molded parts of short-fiber-reinforced thermoplastics

✍ Scribed by Takaaki Matsuoka; Jun-Ichi Takabatake; Yoshinori Inoue; Hideroh Takahashi

• Publisher: Society for Plastic Engineers
• Year: 1990
• Tongue: English
• Weight: 883 KB
• Volume: 30
• Category: Article
• ISSN: 0032-3888
• DOI: 10.1002/pen.760301605

✦ Synopsis

Abstract

Fiber orientation induced by injection mold filling of short‐fiber‐reinforced thermoplastics (FRTP) causes anisotropy in material properties and warps molded parts. Predicting fiber orientation is important for part and mold design to produce sound molded parts. A numerical scheme is presented to predict fiber orientation in three‐dimensional thin‐walled molded parts of FRTP. Folgar and Tucker's orientation equation is used to represent planar orientation behavior of rigid cylindrical fibers in concentrated suspensions. The equation is solved about a distribution function of fiber orientation by using a finite difference method with input of velocity data from a mold filling analysis. The mold filling is assumed to be nonisothermal Hele‐Shaw flow of a non‐Newtonian fluid and analyzed by using a finite element method. To define a degree of fiber orientation, an orientation parameter is calculated from the distribution function against a typical orientation angle. Computed orientation parameters were compared with measured thermal expansion coefficients for molded square plates of glass‐fiber‐reinforced polypropylene. A good correlation was found.