✦ LIBER ✦

Prediction of fatigue crack growth and residual life using an exponential model: Part I (constant amplitude loading)

✍ Scribed by J.R. Mohanty; B.B. Verma; P.K. Ray

Publisher: Elsevier Science
Year: 2009
Tongue: English
Weight: 267 KB
Volume: 31
Category: Article
ISSN: 0142-1123
DOI: 10.1016/j.ijfatigue.2008.07.015

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Prediction of fatigue crack growth and r

Prediction of fatigue crack growth and residual life using an exponential model: Part II (mode-I overload induced retardation)

✍ J.R. Mohanty; B.B. Verma; P.K. Ray 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 352 KB

Almost all load bearing components usually experience variable amplitude loading (VAL) rather than constant amplitude loading (CAL) during their service lives. A single overload cycle introduced in a constant amplitude fatigue loading retards fatigue crack growth and increases residual fatigue life.

Crack growth-based fatigue life predicti

Crack growth-based fatigue life prediction using an equivalent initial flaw model. Part I: Uniaxial loading

✍ Yibing Xiang; Zizi Lu; Yongming Liu 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 522 KB

Crack growth-based fatigue-life predicti

Crack growth-based fatigue-life prediction using an equivalent initial flaw model. Part II: Multiaxial loading

✍ Zizi Lu; Yibing Xiang; Yongming Liu 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 435 KB

A general methodology is proposed in this paper for fatigue-life prediction using crack growth analysis. This is the part II of the paper and focuses on the fatigue-life prediction under proportional and nonproportional multiaxial loading. The proposed multiaxial fatigue-life prediction is based on

Fatigue life prediction of corrosion-dam

Fatigue life prediction of corrosion-damaged high-strength steel using an equivalent stress riser (ESR) model: Part I: Test development and results

✍ D.T. Rusk; W. Hoppe 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 848 KB

The fatigue life of metallic aircraft structural components can be significantly reduced by environmentally induced corrosion. As part of a NAVAIR High Strength Steel Corrosion-Fatigue Assessment Program, methods were studied to predict the impact that corrosion-induced surface roughness has on the