Practical Aspects of Active PhasedArray Antenna Development
Contents
Preface
1Practical Aspects of Active Phased Array Antenna Development
1.1 Introduction
1.2 Active Phased Array Antenna System
1.3 Passive Phased Array Antenna
1.4 Passive Phased Array Antenna Limitations
1.5 Active Phased Array Antenna
1.6 Key Radar System-level Advantages of Active Phased Arrays over Passive Phased Arrays
1.6.1 Increased Sensitivity
1.6.2 Improved Target Detection in Clutter
1.6.3 Improved Waveform and Pattern Flexibility
1.6.4 Improved Wideband Operation
1.6.5 Increased Reliability
1.6.6 Reduced Prime Power Requirement
1.6.7 Reduced Cost
1.6.8 Lower Noise Temperature/Figure
1.6.9 Adaptive and Digital Beamforming
1.7 Tracking Radar Performance Metric
1.8 Introductions to the Chapters
1.9 Concluding Remarks
References
2Analysis and Design of Linear and Planar Phased Arrays
2.1 Introduction
2.2 Analysis of Linear Arrays
2.3 Low Sidelobes for Linear Arrays
2.4 Low Sidelobe Aperture Distributions
2.4.1 Dolph-Chebyshev Aperture Distribution
2.4.2 Taylor Distribution for Linear Arrays
2.4.3 Bayliss Distribution for Difference Patterns
2.4.4 Implementation of Monopulse Beams for an Active Planar Phased Array Antenna
2.5 Analysis and Synthesis of Planar Arrays
2.5.1 Rectangular Grid
2.5.2 Triangular Array Element Grid
2.6 Comparison of Rectangular and Triangular Grids
2.7 Minimize the Number of Elements for a Grating Lobe-free Pattern Using a Tilted Array
2.8 Directivity and Gain of Active Arrays
2.9 Effect of Amplitude and Phase Errors on the Phased Array Antenna Performance
2.9.1 Quantization Errors
2.9.2 RMS Sidelobe Level Due to Amplitude and Phase Errors
2.10 Beam Pointing Error Due to Phase Quantization
2.11 Bandwidth Criteria for Active Phased Array Antennas
2.11.1 Instantaneous Bandwidth
2.11.2 Phased Array Operating Bandwidth
2.12 Moderate Instantaneous Wide Bandwidth Array by Applying Amplitude Taper in the Receiver
2.13 Concluding Remarks
References
3Transmit/Receive Modules
3.1 Introduction
3.2 T/R Module Architecture
3.2.1 Control Module
3.2.2 Integration of T/R Module with DC-to-DC Converter
3.2.3 Shared Leg T/R Module Architecture
3.3 Active Phased Array Performance Improvement
3.3.1 GaN Wide Bandgap Power Amplifiers
3.4 T/R Module Key Performance Parameters
3.4.1 Power-Added Efficiency
3.4.2 T/R Module Noise Figure
3.4.3 Noise Figure of a Cascaded Network
3.4.4 T/R Module Noise Temperature
3.4.5 1-dB Compression Point
3.4.6 Third-Order Intercept Point
3.5 T/R Module Architecture Tradeoffs
3.6 T/R Module Architectures for Circular Polarization
3.7 T/R Module Construction
3.8 Thermal Stack-Up of the T/R Module
3.9 Integration of MMIC, Control Module, and DC-to-DC Converters
3.10 T/R Module Stability
3.11 T/R Module Reliability
3.12 T/R Module Cost
3.13 Performance Requirements of T/R Modules
3.14 Application of Silicon Germanium (SiGe) BiCMOS Technology in T/R Modules
3.15 Concluding Remarks
References
4Beamformer Architectures for Active Phased Array Antennas
4.1 Introduction
4.2 Beamformer Networks for Passive Phased Array Antennas
4.3 Beamformer Networks for Active Phased Array Antennas
4.3.1 Multiple Independent Receive Beams
4.4 Impact of Beamformer Architecture on System Noise Temperature
4.5 Beamformer Architectures for High Reliability
4.6 Beamformer Networks for Wideband Active Phased Array Antennas
4.7 Concluding Remarks
References
5Radiating Elements
5.1 Introduction
5.2 Printed Circuit Radiating Elements
5.2.1 Printed Circuit Wideband Radiating Elements
5.3 Waveguide Radiating Elements
5.3.1 A Wideband Tapered Double-Ridged Waveguide Element Fed by a Coaxial Probe
5.4 Radome Heating for Ice Inhibition
5.5 Wideband Parallel Waveguide Phased Array Radiator
5.6 Mutual Coupling Between Radiating Elements
5.7 Selection of the Radiating Element Type
5.8 Radiating Element Design Process
5.9 Phased Array Radiation Pattern Calculation by Using the Mutual Coupling Between Elements in a Small Array
5.10 Concluding Remarks
References
6Beam Steering and DC Power Distribution
6.1 Active Phased Array Antenna Beam Steering Controller
6.1.1 Active Phased Array Distributed Beam Steering Controller
6.1.2 Active Phased Array Centralized Beam Steering Controller
6.2 Active Phased Array Power Distribution
6.2.1 DC-to-DC Converter Key Requirements
6.2.2 Distributed Power System
6.2.3 Centralized Power System
6.2.4 Average versus Peak DC-to-DC Converters
6.2.5 Comparison of Distributed and Centralized Power Systems
6.3 Concluding Remarks
References
7Active Phased Array Antenna Packaging
7.1 Introduction
7.2 Array Packaging Concepts
7.2.1 Tile Array Construction and Cooling Methods
7.2.2 Brick Array Packaging
7.2.3 Components of an LRU
7.2.4 Thermal Management
7.3 Active Array Antenna Brick Packaging Schemes
7.3.1 Sliding Vertical Cold Plate Active Array Packaging
7.3.2 Edge-Cooled, Horizontal Cold Plate Array Packaging
7.3.3 Vertical Fixed Cold Plate Packaging Concept
7.4 LRU to the Radiating Element RF Connections
7.5 Structural Design
7.6 Active Array Antenna Radome Design
7.7 Concluding Remarks
References
8Active Phased Array Antenna Design for High Reliability
8.1 Introduction
8.2 Antenna MTBF
8.3 Active Phased Array Antenna Architecture Description for High Reliability
8.4 Maximizing the Array MTBCF
8.5 Antenna MTBF for Different Cluster Sizes
8.6 Increasing Array MTBCF with Redundant Power Supplies
8.7 Driver Amplifier Boosters in the Active Phased Array Beamformers
8.8 Lifecycle Maintenance Cost Estimation of an Active Phased Array Antenna
8.9 Active Phased Array Antenna Availability and Sparing
8.10 Concluding Remarks
References
9Active Phased Array Design for High Clutter Improvement Factor
9.1 Introduction
9.2 Centralized Phased Array Architecture
9.3 Distributed Array Architecture
9.4 Concluding Remarks
References
10Active Phased Array Antenna Calibration
10.1 Introduction
10.2 Active Array Calibration Using Mutual Coupling Between Array and External Elements
10.3 Active Array Calibration Technique Using Mutual Coupling Between Array Elements
10.4 Active Array Calibration Technique Using Mutual Coupling Between a Few Dedicated Internal Elements and the Array Elements
10.4.1 Calibration Procedure
10.4.2 Required Number of Calibration Elements
10.4.3 Calibration Accuracy
10.4.4 Effect on Array Packaging
10.5 Concluding Remarks
References
11Digital Beamforming for Active Phased Array Antennas
11.1 Introduction
11.2 Dynamic Range Improvement
11.3 Digital Beamforming at Subarray Level
11.4 Digital Beamforming of Multiple Simultaneously Independent Receiver Beams
11.5 Angle Tracking Accuracy
11.6 Adaptive Digital Beamforming
11.6.1 Adapting Nulling in Analog Arrays
11.7 Exciter Noise and Clutter Attenuation
11.8 Concluding Remarks
References
12Cost Reduction Strategies for Active Phased Array Antennas
12.1 Introduction
12.2 High Cost of Current Active Phased Array Antennas
12.3 SPY-1 Array Antenna Cost Reduction
12.4 Improvements in Technology and Manufacturing Processes
12.5 Paradigms
12.5.1 Legacy Systems
12.5.2 Commercial Parts and Processes Are Not Adequate for Military Applications
12.5.3 Cost-Plus Contracts
12.5.4 Lack of Incentives
12.5.5 Schedule Limitations Do Not Permit Any Design Changes
12.5.6 The Benefits of Competition to the Buyer: An Automobile Industry Example
12.5.7 Use the Best Available Technology
12.5.8 Changes Will Increase Program Costs and Schedule Delays
12.6 Design Philosophy
12.6.1 Bottom-Up
12.6.2 Top-Down
12.7 Cost Reduction Strategies
12.7.1 Optimizing T/R Module RF Output Power Levels for Phased Array Antenna Cost, Size, Prime Power, and Dissipated Heat
12.7.2 Trading the Number of Array Faces for a Hemispherical Field of View
12.7.3 Band-Aid Solutions
12.7.4 Antenna Architecture
12.7.5 Minimize the Number of Interfaces
12.7.6 LRU Size versus Cost
12.7.7 Radiating Element
12.7.8 T/R Modules
12.7.9 Module Packaging
12.7.10 DC Power Distribution
12.7.11 Beamformers, Cables, and Connectors
12.7.12 Power-Added-Efficiency and Cost
12.7.13 Active Phased Array Antennas for Wide Bandwidth Operation
12.7.14 Antenna Assembly and Test
12.8 Concluding Remarks
References
Appendix: T/R Module Requirements and Flow Down to the Components
T/R Module Requirements Flow Down (Receive Channel)
About the Author
Index