𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Porous structure of active carbon and ASC whetlerites produced therefrom

✍ Scribed by J. Kloubek; J. Medek; D. Tomanová

Publisher
Elsevier Science
Year
1984
Tongue
English
Weight
497 KB
Volume
22
Category
Article
ISSN
0008-6223

No coin nor oath required. For personal study only.

✦ Synopsis

A set of samples, including active carbon and ASC-whetlerites, both in their original form and after extraction, all with an identical carbonaceous skeleton, was investigated to specify the porous structure and the deposition of the impregnant. Mercury porosimetry and adsorption of nitrogen and carbon dioxide were used for this purpose. The thickness of the deposited layer increases with pore radius. In macropores of r -1000 nm with the largest relative frequency, the thickness of the impregnant is about 120nm. The deposit may somewhat remove unevenness in the pore walls, but, on the other hand, it creates a secondary pore structure in macropores, where the thickness of the deposit is high enough. Also a partial clogging of small pores takes place.

📜 SIMILAR VOLUMES

111. Porous structure of active carbons
111. Porous structure of active carbons and adsorption kinetics
✍ A.M. Volochtchouk; M.M. Dubinin; V.A. Gordeeva 📂 Article 📅 1982 🏛 Elsevier Science 🌐 English ⚖ 129 KB

Chars, prepared by pyrolysis of prune pits at I or lS"C/min to 500, 700 or 9OO"C, were subsequently gasified by CO, at 900°C. Pyrolysis conditions did not significantly affect the porosity developed for a given mass loss due specifically to gasification reactions, i.e. excluding additional pyrolytic

Porous structure and liquid-phase adsorp
Porous structure and liquid-phase adsorption properties of activated carbon aerogels
✍ Wenjin Yang; Dingcai Wu; Ruowen Fu 📂 Article 📅 2007 🏛 John Wiley and Sons 🌐 English ⚖ 246 KB 👁 2 views

## Abstract In this article, activated carbon aerogels (ACAs) were prepared by CO~2~ activation. Their pore structures were investigated by N~2~ adsorption–desorption analysis. ACAs have excellent microporosity (e.g. 0.36 cm^3^/g) and mesoporosity (e.g. 1.72 cm^3^/g). Adsorption characteristics of

Elucidating the porous structure of acti
Elucidating the porous structure of activated carbon fibers using direct and indirect methods
✍ M.A. Daley; D. Tandon; J. Economy; E.J. Hippo 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 1024 KB

The porous structure of a series of commercial activated carbon fibers (ACFs) (with increasing surface area) was studied using both direct and indirect methods. The porous structure was characterized directly using scanning tunneling microscopy (STM) techniques and indirectly using the Dubinin-Radus