✦ LIBER ✦

Pore size distribution of OPC & SRPC mortars in presence of chlorides

✍ Scribed by A.K. Suryavanshi; J.D. Scantlebury; S.B. Lyon

Book ID: 103000614
Publisher: Elsevier Science
Year: 1995
Tongue: English
Weight: 632 KB
Volume: 25
Category: Article
ISSN: 0008-8846
DOI: 10.1016/0008-8846(95)00093-r

No coin nor oath required. For personal study only.

✦ Synopsis

The pore structure of chloride-free ordinary portland cement(OPC) and sulphate resistant portland cement(SRPC) mortars are compared with the corresponding mortars with NaCl and CaCl, added during mixing. In both OPC and SRPC mortars the addition of chlorides reduced the total accessible pore volumes compared to the corresponding chloride-free mortars. Also, in the presence of chlorides, the number of coarse pores were increased. These changes in the pore structure are believed to be due to dense calcium silicate hydrate(C-S-H) gel morphology formed in the presence of chlorides, The SRPC showed greater changes in pore structures than the OPC with equivalent amounts of chlorides added. This may be due to the lower chloride binding capacity of the SIZPC and hence the higher availability of free chlorides to mod@ the gel morphology.

📜 SIMILAR VOLUMES

From pore size distribution to an equiva

From pore size distribution to an equivalent pore size of cement mortar

✍ H. W. Reinhardt; K. Gaber 📂 Article 📅 1990 🏛 Springer 🌐 English ⚖ 978 KB

Pore size distribution and oxygen diffus

Pore size distribution and oxygen diffusion resistance of polymer-modified mortars

✍ Y. Ohama; K. Demura; K. Kobayashi; Y. Satoh; M. Morikawa 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 334 KB

The present paper deals with the resistance of oxygen diffusion of polymer-modified mortars which are often used as low-cost promising materials for repairing work for various reinforced concrete structures. The polymermodified mortars using three types of commercial polymer dispersions, i.e., styre

Synthesis of FDU-1 Silica with Narrow Po

Synthesis of FDU-1 Silica with Narrow Pore Size Distribution and Tailorable Pore Entrance Size in the Presence of Sodium Chloride

✍ Kruk, Michal; Celer, Ewa B.; Matos, Jivaldo R.; Pikus, Stanisław; Jaroniec, Miet 📂 Article 📅 2005 🏛 American Chemical Society 🌐 English ⚖ 115 KB

The effect of chloride ion source on the

The effect of chloride ion source on the free chloride ion percentages in OPC mortars

✍ M.J. Al-Hussaini; C.M. Sangha; B.A. Plunkett; P.J. Walden 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 351 KB

The effect of incorporating varying percentages of sodium chloride (NaCI) and calcium chloride (CaC12) in ordinary Portland cement (OPC) mortar mixes on the free chloride ion content was investigated. After curing for 28 days with different levels of chloride ions, mixes were tested to assess the pe

Through Pore Size Distribution and Kinet

Through Pore Size Distribution and Kinetics of the Carbonation Reaction of Portland Cement Mortars

✍ MASAKI DAIMON; TOKUJI AKIBA; RENICHI KONDO 📂 Article 📅 1971 🏛 John Wiley and Sons 🌐 English ⚖ 646 KB

The effect of different drying technique

The effect of different drying techniques on the pore size distribution of blended cement mortars

✍ L. Konecny; S.J. Naqvi 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 471 KB

Porosity and pore size distribution measurements using mercury intrusion are reported for blended mortars (incorporating fly ash) dried by four different drying techniques. The drying techniques were: direct oven drying, solvent replacement drying, and two variations of freeze drying. Significant di