Polymorphic flecainide disposition under conditions of uncontrolled urine flow and pH
β Scribed by A. S. Gross; G. Mikus; C. Fischer; M. Eichelbaum
- Publisher
- Springer
- Year
- 1991
- Tongue
- English
- Weight
- 802 KB
- Volume
- 40
- Category
- Article
- ISSN
- 0031-6970
No coin nor oath required. For personal study only.
β¦ Synopsis
The pharmacokinetics of R- and S-flecainide have been determined in five poor (PM) and five extensive (EM) metabolisers of sparteine/debrisoquine under conditions of uncontrolled urine flow and pH. The half-lives of R- and S-flecainide in PMs (R 19.3 h; S 16.1 h) were approximately twice those observed in EMs (R 8.8 h; S 9.1 h). The apparent oral clearances of R- and S-flecainide were lower in PMs (R 313 ml.min-1; S 379 ml.min-1) than in EMs (R 783 ml.min-1; S 828 ml.min-1). The renal clearance, however, was comparable for both enantiomers in both EMs and PMs, and therefore the phenotypic differences in flecainide disposition observed must be due to differences in metabolic clearance. The nonrenal clearance of both enantiomers was significantly lower in poor (R 123 ml.min-1; S 201 ml.min-1) relative to extensive metabolisers (R 533 ml.min-1; S 586 ml.min-1). The partial clearance to the two major metabolites meta-O-dealkylated flecainide (MODF) and the meta-O-dealkylated lactam of flecainide (MODLF) was significantly lower in poor (62 ml.min-1) than extensive (267 ml.min-1) metabolisers. The impairment in flecainide metabolism in poor metabolisers of sparteine/debrisoquine has therefore been confirmed. Under conditions reflecting the clinical situation the difference in disposition between EMs and PMs would be considerable. However, it may be predicted that at standard doses concentrations greater than 1000 ng.ml-1 would not be attained in the PMs studied.(ABSTRACT TRUNCATED AT 250 WORDS)
π SIMILAR VOLUMES
## Abstract Corrosion rates determined on the basis of weight loss and polarization resistance are considerably lower for a 6% chromium steel than for an unalloyed steel C 15 (DIN 17210), a baseβmelt and a 5.5% Ni steel. The results of a 100 hrs test and a short duration parameter studies at variou