𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Planar Quadrature Coil Design Using Shielded-Loop Resonators

✍ Scribed by Anders Stensgaard


Publisher
Elsevier Science
Year
1997
Tongue
English
Weight
561 KB
Volume
125
Category
Article
ISSN
1090-7807

No coin nor oath required. For personal study only.

✦ Synopsis


The shielded-loop resonator is known to have a low capacitive between the modes can be finely adjusted by tuning the sample loss due to a perfect balancing. In this paper, it is demonbalance between C 1 and C 2 . To maintain the isolation, the strated that shielded-loop technology also can be used to improve two connection points of the single loop to the center connecdesign of planar quadrature coils. Both a dual-loop circuit and tor must be at virtual ground during operation. This is rather especially a dual-mode circuit may benefit from use of shieldeddifficult to accomplish if a capacitive match circuit is used. loop resonators. Observations in measurements agree with theory In Ref. (4), two capacitive tune-and-match circuits are for both a dual-loop coil and a dual-mode coil. The coils were shown, a passive and an active circuit. Besides being rather designed for use as transmit/receive coil for 1 H imaging and speccomplicated, both circuits suffer from the problem that there troscopy at 4.7 T in rat brain.


πŸ“œ SIMILAR VOLUMES


Optimized Design of the Shielded-Loop Re
✍ Anders Stensgaard πŸ“‚ Article πŸ“… 1996 πŸ› Elsevier Science 🌐 English βš– 155 KB

The shielded-loop resonator is known to have low capacitive an outer shield conductor. In a coaxial cable or any other sample loss due to perfect balancing. We present a new analysis shielded system, the skin effect in the conductor isolates the of the unbalanced driven shielded-loop resonator that

Microstrip bandpass filter design using
✍ Haiwen Liu; Mingtao Tan πŸ“‚ Article πŸ“… 2009 πŸ› John Wiley and Sons 🌐 English βš– 165 KB

## Abstract In this letter, a highly selective microstrip bandpass filter using triangular open‐loop resonators with improved cross‐coupled structure is designed, fabricated, and measured. The new cross coupling structure is implemented by inserting two L‐shaped stubs into the triangular open‐loop

Design of a new compact dual-mode multib
✍ Ahmed Boutejdar πŸ“‚ Article πŸ“… 2010 πŸ› John Wiley and Sons 🌐 English βš– 585 KB

## Abstract In this article, we proposed at first step a new compact dual‐mode bandstop filter with broad stopband and low insertion loss in the passband using one ring resonator.Based of this microstrip ring resonator, a novel type of multibandpass filters is proposed. The idea of the proposed fil

A solid reusable endorectal receiver coi
✍ Nandita M. Desouza; David J. Gilderdale; Rakesh Puni; Glyn A. Coutts; Ian R. You πŸ“‚ Article πŸ“… 1996 πŸ› John Wiley and Sons 🌐 English βš– 469 KB πŸ‘ 1 views

## Abstract We have designed a solid endorectal receiver coil for MRI of the prostate. The coil provided an improved signal‐to‐noise ratio up to 5 cm from its surface when compared with a standard pelvic phased array. This preliminary report describes 16 patients who were imaged using this coil, se

Computer-aided design of 3D microwave fi
✍ H. Blondeaux; S. Bila; D. Baillargeat; S. Verdeyme; P. Guillon; A. Carlier; E. R πŸ“‚ Article πŸ“… 2000 πŸ› John Wiley and Sons 🌐 English βš– 219 KB πŸ‘ 1 views

A dielectric resonator filter is proposed for high-speed data communication systems and for multilayer filter applications. The structure is composed of a partially metallized dielectric plate enclosed in a parallelepipedic cavity. This topology allows high integration in a planar-type environment.