Polybutadienes (PBs) of narrow molecular weight distributions with high 1,4-microstructure were synthesized by sec-butyllithium-initiated, living polymerization. The shoulder-like anomalous behavior of the storage modulus GЈ() in the terminal zone for PBs was studied using size exclusion chromatogra
Ozonolysis of polybutadienes with different microstructure in solution
✍ Scribed by M. P. Anachkov; S. K. Rakovsky; G. E. Zaikov
- Publisher
- John Wiley and Sons
- Year
- 2007
- Tongue
- English
- Weight
- 128 KB
- Volume
- 104
- Category
- Article
- ISSN
- 0021-8995
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
The reaction of ozone with 1,4‐cis‐polybutadiene and polybutadiene having the following linking of the butadiene units: 1,4‐cis (47%), 1,4‐trans (42%), 1,2 (11%) was investigated in CCl~4~ solution. It was found out by means of IR‐spectroscopy and ^1^H‐NMR spectroscopy that the basic ozonolysis products of both elastomers are ozonides and aldehydes. The aldehyde:ozonide ratio was 11 : 89 and 27 : 73 for E‐BR and BR, respectively. In addition, epoxide groups were detected, only in the case of BR, and their yield was about 10% of that of the aldehydes. On the basis of BR ozonolysis it was established that the ozonide yield from 1,4‐trans units is about 50%. By using the aldehyde yields, an evaluation was made of the efficiency of ozone degradation of the two polybutadienes, according to which the respective value of BR is considerably higher than that of E‐BR. A reaction mechanism is proposed, which explains the formation of the identified functional groups and the differences in the ozone degradation of the studied elastomers. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 427–433, 2007
📜 SIMILAR VOLUMES
## Abstract **Summary:** The microstructure of ethylene‐norbornene copolymer produced in solution polymerization is analyzed through kinetic modeling and experiments using homogeneous __rac__‐Et(1‐indenyl)~2~ZrCl~2~/methylaluminoxane catalyst in toluene at 70 °C. The sequence distribution function
Two implant types of hydroxyapatite (HA) currently are available for dental implants: dense HA-cemented titanium (Ti) and HA-coated. It has been shown in previous reports that there are differences in the chemical and mechanical stabilities between the dense HA and HA coated. The differences are tho