The increasing demands for improved performance, especially in the aerospace industry, have led to the development of new materials with improved mechanical properties combinations. In particular, where weight considerations are in demand, both in terms of cost and performance, the use of low densit
✦ LIBER ✦
Oxygen dependent SIMS yields in AlSiMg alloy
✍ Scribed by E. Furman; Y. Finkelshtein
- Publisher
- Elsevier Science
- Year
- 1987
- Tongue
- English
- Weight
- 121 KB
- Volume
- 37
- Category
- Article
- ISSN
- 0042-207X
No coin nor oath required. For personal study only.
📜 SIMILAR VOLUMES
Rapid solidification of MgAlZnSi allo
✍
J.A. Juarez-Islas
📂
Article
📅
1991
🏛
Elsevier Science
🌐
English
⚖ 396 KB
Clustering in AlMgGe alloy
✍
S. Ceresara; P. Fiorini
📂
Article
📅
1968
🏛
Elsevier Science
⚖ 309 KB
Strain concentration at grain boundaries
✍
P. Singh; J.T. Evans; N.J.H. Holroyd
📂
Article
📅
1992
🏛
Elsevier Science
🌐
English
⚖ 963 KB
Grain boundary sliding has been observed in an A1-Mg-Si alloy deformed at room temperature. The extent of sliding was primarily a function of the macroscopic strain whether this was produced by creep or in slow-strain-rate tensile tests but was more intense at low strain rates than at high strain ra
Investigation of Mg loss during heat tre
✍
I. Kovács; J. Lendvai; T. Ungár
📂
Article
📅
1975
🏛
Elsevier Science
⚖ 373 KB
Strain induced macrosegregation in squee
✍
Tone Rølland; Robert Flatval; Lars Arnberg
📂
Article
📅
1993
🏛
Elsevier Science
🌐
English
⚖ 603 KB
Superplasticity in an AlZnMgCu alloy
✍
P. Málek
📂
Article
📅
1991
🏛
Elsevier Science
🌐
English
⚖ 450 KB